Scribd
Upload
60 views1 page

Fig. 6 - Wear On Belt Grooves Fig. 7: Mounting and Adjusting of The V-Belt Drive

The document provides instructions for mounting and adjusting a V-belt drive system. It describes how to clean and prepare the belt pulleys, shafts, and bushings. It then lists the steps to mount the motor pulley and compressor pulley, including placing them on their respective shafts so that the keys enter the key grooves, and securing them with screws and washers. Proper tightening of the screws is emphasized so that the pulleys can still be moved by hand for adjustment.

Uploaded by

arness22
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
60 views1 page

Fig. 6 - Wear On Belt Grooves Fig. 7: Mounting and Adjusting of The V-Belt Drive

The document provides instructions for mounting and adjusting a V-belt drive system. It describes how to clean and prepare the belt pulleys, shafts, and bushings. It then lists the steps to mount the motor pulley and compressor pulley, including placing them on their respective shafts so that the keys enter the key grooves, and securing them with screws and washers. Proper tightening of the screws is emphasized so that the pulleys can still be moved by hand for adjustment.

Uploaded by

arness22
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Fig. 6 - Wear on Belt Grooves Fig.

Pos. 2

wear _____.-

The Motor Pulley


The measuring gauge is available from our
After-Market Service Department and has the • First place the motor pulley on the motor
following Part no. 1622.001. shaft. Then turn the bushing so that the
key on the shaft enters the key groove of
the bushing.
It must be possible to fit the bushing ma-
Mounting and Adjusting of the nually. It is not recommended to beat at
V-Belt Drive the bushing as this procedure may dama-
ge the bearings of the motor.
Modern V-belt drives are very sturdy and ef-
fective, but require on the other hand • Turn the belt pulley so that all the
a correct installation and adjustment. threaded holes in the pulley face the
smooth holes in the bushing as is shown
in fig. 8.
Before mounting the V-belt drive, it is neces-
sary to clean and degrease all machined sur-
Fig. 8
faces of the belt pulleys, shafts and bushing.
Bush no. Bush no.
Then proceed as follows: TB 1008-3030 TB 3525-5050

The Compressor Pulley

• Place the compressor pulley on the coni-


cal shaft and turn it so that the key on the
shaft faces the key groove.

" Oil the two or three socket cap screws, fig.


• Mount the washer, pos. 1, and the screw, 8, and mount them in the above-mentio-
pos. 2, as shown in fig. 7 and tighten them ned holes. Tighten the screws exactly
to a torque of 130 Nm. so much that it is still possible to move

152 0171 -370-EN

You might also like