Tiger Lifting
www.tigerlifting.com
Home of the Tiger hoisting, winching and height safety ranges
Tiger Wire Rope Pulling Machine
Model No. TRPA/TRPS
TRPS (Steel) TRPA (Aluminium)
Main Features
Range from 800kg to 5400kg (Lifting Capacity)
Lightweight manual pulling machines - simple and safe to operate
Compact high-strength
Corrosion free aluminium alloy casing or steel versions available
Usable at horizontal, vertical and angled working positions
20m steel wire with eye hook as standard
Rope clamp system easily disengaged with a lever allowing smooth installation of wire rope
Equipped with an anchor bolt offering numerous connection possibilities
Overload protection built in, with a shearing pin in the forward lever
Shear pins can be replaced without removing the load
Spare shear pins supplied
Parallel clamping system providing evenly distributed grip at a lower force, resulting in less rope
wear
Individually serial numbered for traceability
Supplied with relevant certification and user instructions
14 July 2017 Page 1 of 4
Tiger Lifting
www.tigerlifting.com
Home of the Tiger hoisting, winching and height safety ranges
Tiger TRPA/TRPS Wire Rope Pulling Machines
The manual wire rope puller is a hand operated lifting and pulling device. The puller could also be used for
lowering, tensioning and guying which makes it a versatile, portable and multipurpose tool.
The principle function of the wire puller is that the rope passes through mechanical jaws rather than being
reeled on a drum of a puller or conventional winch. The tension of the rope is applied by means of two
pairs of self-energised jaws which apply a grip onto the wire rope in sections. The effort is transferred to
the jaws by two parallel levers, one for forward operation and the other for reverse operation. A telescopic
bar, fitted to either the forward or reverse lever, transmits the effort to the jaw mechanism. This parallel
clamping system provides an evenly distributed grip at a lower force, resulting in less rope wear. The load is
held securely at all times.
The wire rope puller comes with a telescopic operating handle* and 20 metres of wire rope fitted with an
eye-type hook as standard. Any length of rope can be supplied to your requirements. Alternatively the wire
rope puller is available as a machine only, without wire rope. (*the operating handle with the 800kg
TRPA/TRPS is not telescopic)
These units meet and exceed all the requirements within BS EN 13157:2004+A1:2009.
Increase the Pulling and Lifting Capacity:
Various methods of rigging are shown. For the correct and incorrect method refer to figures 1 and 2. Other
methods of rigging will increase the capacity of the machine – refer to figures 3 and 4.
Figure 1 Figure 2
Figure 3
14 July 2017 Page 2 of 4
Tiger Lifting
www.tigerlifting.com
Home of the Tiger hoisting, winching and height safety ranges
In examples 3 and 4 the maximum working load limit (WLL) of the pulley and anchor point shall be equal to
or greater than two times the WLL.
NOTE: When the wire rope puller is anchored directly to a fixed point, ensure that there are no
obstructions around the machine which could prevent the wire rope, puller and anchor from operating in a
straight line.
It is recommended to use a sling of similar capacity between the anchor point and the unit.
Figure 4
WARNING: Any rigging configuration which requires the calculation of forces applied should be checked by
a competent engineer, with special attention to the strength of the fixed point used.
Certification:
Each unit comes fully certified with a test certificate or an EC Declaration of Conformity stating compliance
with the essential health and safety requirements of the Machinery Directive 2006/42/EC.
14 July 2017 Page 3 of 4
Tiger Lifting
www.tigerlifting.com
Home of the Tiger hoisting, winching and height safety ranges
Technical Data
Tiger wire rope pullers are available in two models with the following capacities:
ALUMINIUM CASING
Product Code WLL Pulling Rope Breaking Effort Advance Net Overall Overall Overall
(kg) Capacity Diameter strain (kN) (kg) /Pull Weight Length Height Width
(kg) (mm) (mm) (kg) (mm) (mm) (mm)
TRPA-08 800 1200 8.3 43 35 52 6.0 426 235 64
TRPA-16 1600 2400 11 120 41 55 11.0 545 280 97
TRPA-32 3200 4800 16 162 45 28 22.0 660 325 116
TRPA-54 5400 8000 20 264 76 30 59.0 930 480 152
STEEL CASING
Product Code WLL Pulling Rope Breaking Effort Advance Net Overall Overall Overall
(kg) Capacity Diameter strain (kN) (kg) /Pull Weight Length Height Width
(kg) (mm) (mm) (kg) (mm) (mm) (mm)
TRPS-08 800 1200 8.3 43 35 52 8.0 440 265 63
TRPS-16 1600 2400 11 120 41 55 14.5 550 300 77
TRPS-32 3200 4800 16 162 45 28 28.0 690 350 91
Due to our policy of continual product development, dimensions, weights and specifications may change without
prior notice. Please check with your Tiger sales team when ordering.
14 July 2017 Page 4 of 4
