Scribd
Upload
98 views2 pages

Olympian Technical Information Bulletin: 02 March 2011 SUBJECT: 400 Series Starter Motor Wiring

The document provides technical information about wiring starter motors on 400 series gensets. It describes how cables should be routed through a red insulating boot to the positive stud on the starter motor solenoid and oriented properly to avoid fouling the solenoid casing.

Uploaded by

Nacer Zehani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
98 views2 pages

Olympian Technical Information Bulletin: 02 March 2011 SUBJECT: 400 Series Starter Motor Wiring

The document provides technical information about wiring starter motors on 400 series gensets. It describes how cables should be routed through a red insulating boot to the positive stud on the starter motor solenoid and oriented properly to avoid fouling the solenoid casing.

Uploaded by

Nacer Zehani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Olympian

Technical Information
Bulletin
TIB 0070
02 March 2011

SUBJECT: 400 Series starter motor wiring

Safety

Follow FGW Safety rules and H&S handbook


Ensure machine is isolated from AC loads and sources, and disconnect DC batteries.

Description

It is possible that some 400 series gensets may have poorly routed connections onto the
positive stud on the starter motor solenoid. All of the cables should be routed through the red
insulating boot as shown in the below photograph:

Insulating boot shown in position:

Page 1 of 2
Please ensure the terminals are oriented as shown below to ensure there is no risk of
connections fouling the starter solenoid casing – insulating boot removed for clarity:

For more information contact CPI@fgwilson.com

Page 2 of 2

You might also like