05–424
DIAGNOSTICS     –   SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
                                                                                                 05258–08
                                    PRE–CHECK
                                    1.      SRS WARNING LIGHT CHECK
                                    (a)     Turn the ignition switch to the ON position and check that
                                            the SRS warning light lights up.
                                    (b)     Check that the SRS warning light goes out after approx.
                                            6 seconds.
                                    HINT:
                                           When the ignition switch is at ON and the SRS warning
                           C93955
                                            light remains on or flashes, the airbag sensor assembly
                                            has detected a malfunction code.
                                           If, after approx. 6 second have elapsed, the SRS warning
                                            light sometimes lights up, a short in the SRS warning light
                                            circuit can be considered likely. Proceed to ”SRS warning
                                            light circuit malfunction” on page
                                            05–585 and 05–588.
                 Tc
                                    2.   DTC CHECK ( using diagnosis check wire)
                                    (a)  Present troubles codes:
                                         Output the DTC.
                                         (1) Turn the ignition switch to the ON position and wait
                                              for approx. 60 seconds.
                                         (2) Using SST, connect terminals Tc and CG of the
                                              DLC3.
                                         SST 09843–18040
                      CG   H40173   NOTICE:
                                    Pay due attention to the terminal connecting position to
                                    avoid a malfunction.
                                    (b) Past troubles codes:
                                         Output the DTC.
                                         (1) Using service wire, connect terminals Tc and CG of
                                              the DLC3.
                                         SST 09843–18040
                                         (2) Turn the ignition switch to the ON position and wait
                                              for approx. 60 seconds.
                                    NOTICE:
                                    Pay due attention to the terminal connecting position to
                                    avoid a malfunction.
2004 COROLLA (RM1037U)
                                                         Author:              Date:              589
                                                                                                          05–425
                                       DIAGNOSTICS    –   SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
 Normal Code (w/o Past Trouble Code)         (c)    Read the DTC.
                                                    Read the 2–digit DTC as indicated by the number of times
          0.25                                      the SRS warning light blinks. As an example, the blinking
    ON                                              patterns, normal, 11 and 31 are shown in the illustration.
                                                               Normal code indication (w/o past trouble
    OFF                                                         code)
                                                                The light will blink 2 times per second.
           0.25                                                Normal code indication (w/ past trouble code)
 Normal Code (w/ Past Trouble Code)                             When the past troubles code is stored in the
          0.75
                                                                airbag sensor assembly, the light blinks only
    ON                                                          ones a second.
                                                               Malfunction code indication
    OFF                                                         The first blinking output indicates the first digit
                                                                of a 2–digit DTC. After a 1.5–second pause,
              0.25
 Malfunctioning Code                                            the second blinking output will indicate the
 (Example Code 11 and 31)                                       second digit.
          0.5 2.5         4.0
                                             If there are 2 or more codes, there will be a 2.5–second pause
                                             between each code. After all the codes have been output, there
                                             will be a 4.0–second pause and they will all be repeated.
                                Repeat
                                             HINT:
           1.5    0.5
                                             In the event of a number of trouble codes, indication will start
          DTC11    DTC31                     from the smallest numbered code.
                                    H13050
3.    DTC CHECK (Using hand–held tester)
(a) Hook up the hand–held tester to the DLC3.
(b) Read the DTCs by following the prompts on the tester screen.
HINT:
Please refer to the hand–held tester operator’s manual for further details.
4.    DTC CLEARANCE (Not using service wire)
(a) When the ignition switch is turned off, the diagnostic trouble code is cleared.
HINT:
DTC might not be cleared by turning the ignition switch OFF. In this case, proceed to the next step.
5.    DTC CLEARANCE (Using service wire)
(a) Using a service wire, connect terminals TC and CG of the DLC3.
(b) Disconnect terminal TC of DLC3 within 10 seconds after the DTC begins to be output, and check if
      the warning light lights up within 3 seconds.
(c) Within 2.0 seconds to 4.0 seconds after the SRS warning light lights up, connect the terminals TC and
      CG of the DLC3.
(d) Light the SRS warning light goes off 2.0 to 4.0 seconds after connecting the terminals TC and CG of
      DLC3, then disconnect the terminal TC of the DLC3 2.0 to 4.0 seconds after the warning light goes
      off.
(e) Light the SRS warning light on again 3 seconds after disconnecting terminal TC of DLC3, then within
      2.0 to 4.0 seconds after the lighting, connect terminals TC and CG of the DLC3.
(f)   Check if the SRS warning light goes off 2.0 to 4.0 seconds after connecting terminals TC and CG of
      DLC3, and the correct code is output 1 second after the SRS warning goes off.
2004 COROLLA (RM1037U)
                                                                Author:               Date:               590
05–426
                                              DIAGNOSTICS   –    SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
If DTCs are to cleared, repeat the above procedure until the codes are cleared.
         IG S/W                ON
                               OFF
         DLC3                  Open
          TC
                               Short
                                                 0.5 sec.       0.5 sec.                      0.25 sec. 0.25 sec.
             CG
      SRS Warning
           Light (*)
                                                            1.5 sec.
                                        T1      T2    T3         T4        T5 T6 T5 T6 T5 T6 T5 T7
                       T1: 0 – ∞ second
                       T2: approx. 6 second
                       T3: 3 – 5 second
                       T4: 3 – 10 second
                       T5: 2 – 4 second
                       T6: 1 – 5 second
                       T7: within 1 second
                *: The past trouble code in the illustration shows DTC 21 as an example.
                                                                                                                    H41917
2004 COROLLA (RM1037U)
                                                                           Author:           Date:                591
                                                                                                        05–427
                                        DIAGNOSTICS   –   SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
6.    DTC CLEARANCE (Using hand–held tester)
(a) Hook up the hand–held tester to the DLC3.
(b) Clear the DTCs by following the prompts on the tester screen.
HINT:
Please refer to the hand–held tester operation’s manual for further details.
7.    RELEASE METHOD OF AIRBAG ACTIVATION PREVENTION MECHANISM
(a) An airbag activention prevention mechanism is built into the connector for the squib circuit of the SRS.
      When release of the airbag activation prevention mechanism is directed in the troubleshooting proce-
      dure, as shown in the illustration of the connectors on the next pages, insert paper which has the same
      thickness as the male terminal between the terminal and the short spring.
CAUTION:
Never release the airbag activation prevention mechanism on the squib connector.
NOTICE:
     Do not release the airbag activation prevention mechanism unless specifically directed by the
      troubleshooting procedure.
     If the inserted paper is too thick the terminal and short spring may be damaged, so always use
      paper with the same thickness as the male terminal.
 2004 COROLLA (RM1037U)
                                                                Author:               Date:            592
05–428
                         DIAGNOSTICS   –   SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
                                                         7
                                                                      Side Airbag
                                                                      Sensor Assy (RH)
                                                         8
                                                                      Front Seat Airbag
                                                                      Assy (RH) (Squib)
                                                         9
                                                                       Seat Belt
                                                                       Pretensioner (RH)
                                           10            11
                                                                      Front Airbag Sensor (RH)
                  2                                      6             Instrument Panel
   Airbag                                                              Passenger Airbag
                  1
   Sensor                    Spiral Cable Sub–Assy                     Assy (Squib)
                             4                           5
   Assy Center    3                                                    Horn Button
                                                                       Assy (Squib)
                                           12           13
                                                                       Front Airbag Sensor (LH)
                                                        14
                                                                       Seat Belt
                                                                       Pretensioner (LH)
                                                         15
                                                                       Front Seat Airbag
                                                                       Assy (LH) (Squib)
                                                        16
                                                                       Side Airbag
                                                                       Sensor Assy (LH)
                                                                                            H41916
2004 COROLLA (RM1037U)
                                                  Author:              Date:               593
                                                                                                               05–429
                                              DIAGNOSTICS    –   SUPPLEMENTAL RESTRAINT SYSTEM (April, 2003)
                         Airbag Sensor Assy Center Connector
                 2                        1                        3
          Short Spring         Short Spring   Short Spring       Short Spring
                                                    Before Release                        After Release
                                                                          Paper
    Connector    4
                                                        Before Release                    After Release
                                                                                Paper
                         Short Spring
    Connector        6
                                              Before Release                                  After Release
                                                                       Paper
       Short Spring
     Connector       8    15
                                              Before Release                                After Release
                                                                       Paper
          Short Spring
                                                                                                                H41995
2004 COROLLA (RM1037U)
                                                                        Author:              Date:            594