Scribd
Upload
197 views1 page

Tilt Steering Column Inspection

This document provides inspection and replacement instructions for components of a tilt steering column. It lists 7 steps: 1) inspect the steering lock operation, 2) replace the key cylinder if needed, 3) inspect the ignition switch, 4) replace the ignition switch if needed, 5) inspect the key unlock warning switch, 6) replace the key unlock warning switch if needed, and 7) inspect the bearing. Replacement instructions are provided for the key cylinder, ignition switch, and key unlock warning switch.

Uploaded by

juan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
197 views1 page

Tilt Steering Column Inspection

This document provides inspection and replacement instructions for components of a tilt steering column. It lists 7 steps: 1) inspect the steering lock operation, 2) replace the key cylinder if needed, 3) inspect the ignition switch, 4) replace the ignition switch if needed, 5) inspect the key unlock warning switch, 6) replace the key unlock warning switch if needed, and 7) inspect the bearing. Replacement instructions are provided for the key cylinder, ignition switch, and key unlock warning switch.

Uploaded by

juan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SR−15

STEERING − TILT STEERING COLUMN


SR0VN−05

INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.

F08805

2. IF NECESSARY, REPLACE KEY CYLINDER


(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder.
(c) Install a new cylinder.
HINT:
Make sure the key is at the ACC position.
3. INSPECT IGNITION SWITCH (See page BE−15)
F08806 4. IF NECESSARY, REPLACE IGNITION SWITCH
(a) Remove the 2 screws and ignition switch from the column
upper bracket.
(b) Install a new ignition switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page BE−15)
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide the key unlock warning switch out of the column up-
per bracket.
(b) Slide a new key unlock warning switch in the column up-
per bracket.
7. INSPECT BEARING
Check the bearing rotation condition and check for abnormal
noise.
If the bearing is worn or damaged, replace the column tube.

F08497

2000 ECHO (RM750U)

Author: Date: 1005

You might also like