Scribd
Upload
157 views1 page

Film Thickness Per Coat: Technical Data Sheet Pilot QD Primer

This technical data sheet provides information on Pilot QD Primer, including: - Recommended dry and wet film thickness is 40-125 μm and 70-220 μm respectively, with a theoretical spreading rate of 14-4.5 m2/l. - Surface preparation for substrates like carbon steel, aluminum, coated surfaces and wood requires cleaning and degreasing to ensure adhesion. - The primer can be applied by spray, brush or roller, with spray or brush recommended for best results.

Uploaded by

TamerTamer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
157 views1 page

Film Thickness Per Coat: Technical Data Sheet Pilot QD Primer

This technical data sheet provides information on Pilot QD Primer, including: - Recommended dry and wet film thickness is 40-125 μm and 70-220 μm respectively, with a theoretical spreading rate of 14-4.5 m2/l. - Surface preparation for substrates like carbon steel, aluminum, coated surfaces and wood requires cleaning and degreasing to ensure adhesion. - The primer can be applied by spray, brush or roller, with spray or brush recommended for best results.

Uploaded by

TamerTamer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Technical Data Sheet

Pilot QD Primer

Film thickness per coat


Typical recommended specification range

Dry film thickness 40 - 125 μm


Wet film thickness 70 - 220 μm
Theoretical spreading rate 14 - 4.5 m²/l

Surface preparation
To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any
contamination.

Surface preparation summary table

Surface preparation

Substrate Minimum Recommended


Carbon steel St 2 (ISO 8501-1) Sa 2½ (ISO 8501-1)
Aluminium The surface shall be hand or machine Abrasive blast cleaning to achieve a
abraded with non-metallic abrasives surface profile using non-metallic
or bonded fibre machine or hand abrasive media which is suitable to
abrasive pads to impart a scratch achieve a sharp and angular surface
pattern to the surface and to remove profile.
all polish from the surface.
Coated surfaces Clean, dry and undamaged compatible Clean, dry and undamaged compatible
coating (ISO 12944-4 6.1.4) coating (ISO 12944-4 6.1.4)
Wood Clean and dry surface. Surface Clean and dry surface. Surface
contamination is to be removed by contamination is to be removed by
detergents and fresh water cleaning. detergents and fresh water cleaning.

Application
Application methods
The product can be applied by

Spray: Use airless spray.


Brush: Recommended.
Roller: May be used for small areas. Not recommended for first primer coat. Care must be taken
to achieve the specified dry film thickness.

Date of issue: 20 November 2018 Page: 2/5

This Technical Data Sheet supersedes those previously issued.


The Technical Data Sheet (TDS) is recommended to be read in conjunction with the Safety Data Sheet (SDS) and the
Application Guide (AG) for this product. For your nearest local Jotun office, please visit our website at www.jotun.com

You might also like