SUPPLIED BY SML MARINE PAINTS - TEL: 01285 862 132 - WEB: WWW.SMLMARINEPAINTS.CO.
UK
Application Guide
Jotafloor Topcoat
Drying and Curing time
Substrate temperature 23 °C 40 °C
Surface (touch) dry 12 h 3h 1 h
Walk-on-dry 23 h 8h 3 h
Dry to over coat, minimum 23 h 7.5 h 3 h
Dried/cured for service 14 d 7d 3 d
For maximum overcoating intervals, refer to the Application Guide (AG) for this product.
Surface (touch) dry: The state of drying when slight pressure with a finger does not leave an imprint or reveal
tackiness.
Walk-on-dry: Minimum time before the coating can tolerate normal foot traffic without permanent marks,
imprints or other physical damage.
Dry to over coat, minimum: The recommended shortest time before the next coat can be applied.
Dried/cured for service: Minimum time before the coating can be permanently exposed to the intended
environment/medium.
Temperature below 23 degree C will make application more difficult and careful considerations should be given
to storage of materials in cold conditions. Consult Jotun technical team for assistance in such cases.
Maximum over coating intervals
Maximum time before thorough surface preparation is required. The surface must be clean and dry and suitable
for over coating. Inspect the surface for chalking and other contamination and if present, remove with an
alkaline detergent. Agitate the surface to activate the cleaner and before it dries, wash the treated area by low-
pressure water jetting to Wa 1 (ISO 8501-4) using fresh water.
If maximum over coating interval is exceeded the surface should in addition be carefully roughened to ensure
good inter coat adhesion.
Areas for atmospheric exposure
Average temperature during 23 °C 40 °C
drying/curing
Itself 2d 1 d
polyurethane 2d 1d
Adding anti-skid to the coating system
Anti skid should only be added in the final coat and not used in a single coat system direct to the surface.
Spread the Jotafloor Non-slip Aggregate on the surface before half of time to Surface dry. The recommended
usage is 2.5 - 3.3 kg per 10 litres of paint.
Date of issue: 20 January 2019 Page: 4/6
This Application Guide supersedes those previously issued.
The Application Guide (AG) must be read in conjunction with the relevant specification, Technical Data Sheet (TDS) and Safety
Data Sheet (SDS) for all the products used as part of the coating system.
For your nearest local Jotun office, please visit our website at www.jotun.com.
FOR FREE ADVICE AND TRADE PRICES CONTACT SML MARINE PAINTS
