Scribd
Upload
437 views1 page

Factory Standard: PA66-GF30 PP-T20-FR (17) EPDM

This factory standard provides guidelines for identifying and labeling polymer components used in end products manufactured by Miele, Imperial, and their suppliers. It specifies that the base polymer material should be marked between arrows in accordance with relevant DIN standards, using an abbreviation for the polymer and any additives. The character size must be large enough to be legible but not interfere with the component's function.

Uploaded by

adrian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
437 views1 page

Factory Standard: PA66-GF30 PP-T20-FR (17) EPDM

This factory standard provides guidelines for identifying and labeling polymer components used in end products manufactured by Miele, Imperial, and their suppliers. It specifies that the base polymer material should be marked between arrows in accordance with relevant DIN standards, using an abbreviation for the polymer and any additives. The character size must be large enough to be legible but not interfere with the component's function.

Uploaded by

adrian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Factory Standard

Valid for Replaces index no. Date Index no.


Miele, Imperial 2014 part 3/00 01.08.2008 2014 Part 3/01
and From Valid from Page
Suppliers 01.06.99 01.09.2008 1 of 1

Reference

Author (STKZ/FKZ/Name)
GTG/PH/Dahlmann

Title Issued by (STKZ/FKZ)

Identification marking of components made from GTG/KEW


polymer materials
Approved by
GTZ/N

Validity

This Factory Standard applies to all components made of thermoplastics, duroplastics, elastomers
and thermoplastic elastomers used in end products.

Other relevant documents

Standard

DIN EN ISO 11469 - Plastics - Generic identification and marking of plastics products

DIN ISO 1629 - Classification of rubbers and latexes - Abbreviations

Informative

DIN EN ISO 1043 Part 4 - Plastics - Identifying letters and abbreviations, flame retardants

Labelling

The character size depends on the individual part size. It should be as large as possible without
affecting the function of the part. The mark should be made in such a way as to be immediately
apparent after a brief examination of the part. The type of marking must be selected and carried
out such that it is still legible at the end of the product life.

The base polymer should be marked at position "Y" (on the drawing) between the arrows (see
below) in accordance with DIN ISO 11469 or DIN ISO 1629 and it should be possible to change the
marking die in the tool.

Example: >PA66-GF30<
>PP-T20-FR(17)< (Flame Retardant)

>EPDM<

MDS029-06

You might also like