Scribd
Upload
563 views1 page

CNC / DNC Settings For Fanuc 15M and 15T: Parameter Value Comments

The document contains CNC/DNC settings for various Fanuc 15M and 15T controls, listing parameter numbers, their corresponding values, and comments describing options like baud rates and whether to enable functions like TV check, ISO, and drip feed modes. It provides guidance on selecting the tape mode on the control and using the send button on the computer to initiate data transfer and machine motion for drip feeding.

Uploaded by

Cinta Ariesta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
563 views1 page

CNC / DNC Settings For Fanuc 15M and 15T: Parameter Value Comments

The document contains CNC/DNC settings for various Fanuc 15M and 15T controls, listing parameter numbers, their corresponding values, and comments describing options like baud rates and whether to enable functions like TV check, ISO, and drip feed modes. It provides guidance on selecting the tape mode on the control and using the send button on the computer to initiate data transfer and machine motion for drip feeding.

Uploaded by

Cinta Ariesta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Amada CNC / DNC Settings for Fanuc 15M and 15T

Anilam
Bosch Parameter Value Comments  
Boss
 
DeltaDynaPath
Fagor 5001 1  
Fanuc 5002 2  
. . . Fanuc Oi 5003 3  
. . . Fanuc OM
. . . Fanuc OP 5110 4  
. . . Fanuc OT 5111 2  
. . . Fanuc 6 5112 9 * Baud rate - see table below for valid options.
. . . Fanuc 10 5120 4  
. . . Fanuc 11
. . . Fanuc 12 5121 2  
. . . Fanuc 15 5122 9 * Baud rate - see table below for valid options.
. . . Fanuc 16 5130 4  
. . . Fanuc 18
5131 2  
. . . Fanuc 21i
. . . Fanuc 21 5132 9 * Baud rate - see table below for valid options.
Heidenhain 6 = 300
Hinumerik 7 = 600
Hitachi
8 = 1200
Mazak  
Mitsubishi 9 = 2400 * (recommended)
Okuma 10 = 4800
Sinumerik 11 = 9600
Traub
Yasnac  
TV Check 0 0 = TV Check OFF (1= TV Check ON - Never enable TV Check)
ISO 0 0 = ISO (1=EIA Never use EIA)
Input Device 1  
Output
1  
Device
Select Tape mode on the control - Press Cycle Start. At this point nothing
Drip Feed ? happens. Go to the computer and click the 'Send' button. When data begins to
flow the machine will start moving
Note: Not all fanucs of this type can drip feed - must be enabled in the control
   

You might also like