Scribd
Upload
59 views1 page

Maintenance, Troubleshooting: Notice

The document provides maintenance instructions for equipment. It warns not to apply paints or sprays to plastic parts as they contain solvents that can damage coatings. It recommends regularly checking connectors, cabling, ground terminals and wires as part of monthly maintenance and cleaning monitor units and transponders with dry cloths or LCD cleaner.

Uploaded by

craponzel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views1 page

Maintenance, Troubleshooting: Notice

The document provides maintenance instructions for equipment. It warns not to apply paints or sprays to plastic parts as they contain solvents that can damage coatings. It recommends regularly checking connectors, cabling, ground terminals and wires as part of monthly maintenance and cleaning monitor units and transponders with dry cloths or LCD cleaner.

Uploaded by

craponzel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

3.

MAINTENANCE,
TROUBLESHOOTING

NOTICE
ELECTRICAL SHOCK HAZARD Do not apply paint, anti-corrosive sealant
Do not open the equipment. or contact spray to coating or plastic
parts of the equipment.
Only qualified personnel
should work inside the Those items contain organic solvents that
equipment. can damage coating and plastic parts,
especially plastic connectors.

3.1 Maintenance
Regular maintenance is necessary to maintain performance. A monthly
maintenance program should be established and should at least include the
items listed in the table below.

Maintenance items

Item Check point


Connectors Check that all connectors on the rear panel of the transponder
unit and monitor unit are firmly connected.
Cabling Check cabling for damage. Replace if damaged.
Ground terminal Check the ground terminal on the monitor unit and transponder
unit for rust. Clean if necessary.
Ground wire Check that the ground wire on the monitor unit and
transponder unit is firmly fastened.
Monitor unit. Dirt and dust should be removed from units with a soft, dry
Transponder unit cloth. For the LCD, wipe it carefully to prevent scratching,
using tissue paper and an LCD cleaner. To remove dirt or salt
deposits, use an LCD cleaner, wiping slowly with tissue paper
so as to dissolve the dirt or salt. Change paper frequently so
the salt or dirt will not scratch the LCD. Do not use solvents
such as thinner, acetone or benzene for cleaning any unit; they
can remove paint and marks and deform the equipment.

3-1

You might also like