A-1 INSPECTION(S) PTE.
LTD
TECHNICAL PERFORMANCE EVALUATION
Name of Candidate:
Method of Examination: Eddy Current Testing
Date:
-------------------------------------------------------------------------------------------------------------------
1. Knowledge on Eddy current equipment (10)
Demonstrated operations of ET equipment YES/NO
Probe selection YES/NO
2. Understanding set up for calibration. (15)
Setting up Gain Horizontal and Vertical YES/NO
Filter Selection YES/NO
Display selection YES/NO
3. Demonstrated Lift-off effect (20)
Phase Angle Selection YES/NO
Gain Selection YES/NO
4. Calibration (15)
Balancing Done Before testing YES/NO
Identified EDM Notches on the calibration blocks YES/NO
Understand the signal amplitude of the Notches YES/NO
5. Evaluation and Reporting (40)
Followed Correct procedure and standards YES/NO
Identified Mandatory defects YES/NO
Correctly measured and evaluated the indications YES/NO
Report Preparation and Result analysis YES/NO
Marks Obtained:
Percentage: