Scribd
Upload
95 views1 page

Cutting Work Instruction

The document provides work instructions for cutting castings using a cutting machine. It outlines the preparation procedure which includes placing castings in a basket and inspecting equipment. It then describes the cutting procedure which involves turning on the machine, positioning the casting correctly, and lowering the lever to cut until finished.

Uploaded by

Aliff Haiqal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
95 views1 page

Cutting Work Instruction

The document provides work instructions for cutting castings using a cutting machine. It outlines the preparation procedure which includes placing castings in a basket and inspecting equipment. It then describes the cutting procedure which involves turning on the machine, positioning the casting correctly, and lowering the lever to cut until finished.

Uploaded by

Aliff Haiqal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Rigel Metalcraft (M) Sdn. Bhd.

CUTTING WORK INSTRUCTION


Document No: 3-11-13 Rev: 4 Prepare Date: 2003/01/01 Prepared By: Approved By:

Department: FINISHING Review Date: 2023/05/30 Cheah Sin Yin Chen Kao Sung

Cutting Machine Page: 1/1


Handling Instruction (Quality
Procedure Work Instruction
Standard)

Preparation 1. Casting that will be cut is placed in a 1. Wear PPE before work
Procedure steel basket. (semi-leather gloves,
cotton mask, safety
2. Inspect bearing/shaft, pulley belt and v mask, earplug, apron,
belt before started work. arm sleeves, face
shield, cloth wheel)
3. Placed the casting one by one on the
cutting table.

4. Make sure the casting placement is


suitable for cutting blade and make sure
the casting is lined with wooden block.

5. Turn on Dust Collector Machine.

Cutting Procedure.

Operation 1. Turn on cutting machine switch. 1. Hold casting firmly


Procedure during cutting process.
2. Push casting slowly to make sure cutting
placement is correct. If the height of the 2. Stop cutting if fell
blade is correct, continue cutting process. vibration from cutting
blade.
3. Carefully lower cutting machine lever
and continue until finish cutting.
3. Do not remove cutting
4. Casting that has been cut will be placed machine cover.
in steel basket for the next process.
4. Change cutting blade
5. Turn off cutting machine switch when damage.

You might also like