Technical Data Sheet
Kan-Taurus Phenolic Epoxy Zinc Phosphate Primer
Product description
KAN-TAURUS Phenolic Epoxy Zinc Phosphate Primer is two component phenolic based epoxy primer.
Recommended use
It has excellent anti-corrosive properties, excellent chemical and solvent resistance and is specially used in environment where
excellent solvent resistance and heat resistance is required.
Film thickness and spreading rate
Minimum Maximum
Film thickness, dry (μm) 70 80
Film thickness, wet (μm) 110 125
Theoretical spreading rate (m2/l) 8 9
Physical Properties
Colour Red Oxide, Grey Weatherability Must be suitably top
coated
Solids (vol %) 64+/-5% (combine) Water resistance Good
Weight Solids 76+/-5% Abrasion resistance Excellent
Flash Point 22+/-4oC Solvent resistance Excellent
VOC N/A Chemical resistance Excellent
Gloss Matt Toxicity Dry Film Non-Toxic
S. Gravity 1.51+/-0.05 Vary with color Heat Resistance Up to 200oC (dry)
Page 1 of 3
Issue no: 02
Issue date: Feb, 2019
Technical Data Sheet
Surface Preparation
The substrate must be sound, clean, dry and free from dust, oil, grease, laitance etc. All traces of form release agents/curing agents
must be removed. A light sanding with suitable abrasive material is recommended before application. Any resulting dust/loose
particles must be removed.
Recommended Surface Preparation standard: SSPC SP-10
Condition during application
Do not apply at temperature below 10oC or if the Relative humidity exceeds 85% or within 3oC of the Dew Point.
Application Methods
Brush, roller, air assisted or airless spray. Apply an even coat to the recommended film build using a brush or roller. While using a
spray apply one wet coat overlapping the last one by 50%. Standard equipment such as Graco, Hermex, Binks or others using a 30:1
pump ratio for airless spray can be used.
Application data
Mixing ratio 4:1 by Volume
Stir each component thoroughly before mixing. Add Comp. B to Comp. A in the ratio supplied
Mixing
and mix until uniform in color and consistency.
Pot life 2-3 Hours @25oC
Thinner Epoxy Thinner
Drying Time
Relative Humidity:50%
Substrate Temperature 10o 25o 400
Dry to Touch(minutes) 160 120 65
Dry to Handle(hours) 20 16 10
Dry to Recoat 20 16 10
Full Cure 7 days 7 days 7 days
Page 2 of 3
Issue no: 02
Issue date: Feb, 2019
Technical Data Sheet
Typical Paint system
Primer: Kan-Taurus Phenolic Epoxy Zinc Phosphate Primer
Top Coat: Kan-Taurus Phenolic Epoxy finish
Storage
The product must be stored in accordance with national regulations. Keep the containers in a dry, cool, well ventilated space and away
from sources of heat and ignition. Containers must be kept tightly closed. Handle with care.
Handling
Handle with care. Stir well before use.
Packing Size
Available in 4 Liter component A, 1 Liter component B packs.
Certificates
Certificates may be available on request.
Tests
ASTM-D-2196 & D-1200 Viscosity ASTM D-1005 Dry Film Thickness
ASTM-D-1210 Fineness of Dispersion ASTM-D-523 Specular Gloss
ASTM-D-3359 Adhesion by Tape Test ASTM-D-1475 Density
Health & Safety
Please observe the precautionary notices displayed on the container. Use under well ventilated conditions. Do not inhale spray mist.
Avoid skin contact. Spillage on the skin should immediately be removed with suitable cleanser, soap and water. Eyes should be well
flushed with water and medical attention sought immediately. For further info. Please refer to the MSDS for specific product.
Disclaimer
The information in this document is given to the best of Kaizen's knowledge, based on laboratory testing and practical experience. Kaizen cannot guarantee anything but the quality of the
product itself. However, as we have no control over the handling, storage, treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use
of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in
writing by us. Kaizen reserves the right to change the given data without further notice.
Page 3 of 3
Issue no: 02
Issue date: Feb, 2019
