CV3PX310R1
8-port sector antenna, 2x 790–960 and 6x 1710–2690 MHz, 65°
HPBW, 4x RET with manual override.
Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt
with manual override on all arrays
All Internal RET actuators are connected in “Cascaded SRET” configuration
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, high band 6
RF Connector Quantity, low band 2
RF Connector Quantity, total 8
Remote Electrical Tilt (RET) Information, General
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 1 female | 1 male
Dimensions
Width 354 mm | 13.937 in
Length 2533 mm | 99.724 in
Depth 210 mm | 8.268 in
Array Layout
Page 1 of 5
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 17, 2020
CV3PX310R1
Port Configuration
Page 2 of 5
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 17, 2020
CV3PX310R1
Electrical Specifications
Operating Frequency Band 1710 – 2690 MHz | 790 – 960 MHz
Remote Electrical Tilt (RET) Information, Electrical
Protocol 3GPP/AISG 2.0 (Single RET)
Power Consumption, idle state, maximum 2W
Power Consumption, normal conditions, maximum 13 W
Input Voltage 10–30 Vdc
Internal RET High band (3) | Low band (1)
Electrical Specifications
Frequency Band, MHz 790–890 890–960 1710–1920 1920–2170 2300–2690
Page 3 of 5
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 17, 2020
CV3PX310R1
Gain, dBi 16.6 17 16.4 17.1 17.7
Beamwidth, Horizontal, 65 64 61 60 63
degrees
Beamwidth, Vertical, degrees 8.9 8.1 8.3 7.4 5.9
Beam Tilt, degrees 0–10 0–10 0–10 0–10 0–10
USLS (First Lobe), dB 18 19 16 16 15
Front-to-Back Ratio at 180°, 25 28 29 30 30
dB
CPR at Boresight, dB 17 14 17 15 13
CPR at Sector, dB 9 9 7 7 7
Isolation, Cross Polarization, 25 25 25 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30
VSWR | Return loss, dB 1.43 | 15.0 1.43 | 15.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150
Input Power per Port, 300 300 250 250 250
maximum, watts
Electrical Specifications, BASTA
Frequency Band, MHz 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain by all Beam Tilts, 16.4 16.8 16.2 16.8 17.3
average, dBi
Gain by all Beam Tilts ±0.3 ±0.2 ±0.3 ±0.6 ±0.5
Tolerance, dB
Gain by Beam Tilt, average, 0 ° | 16.4 0 ° | 16.8 0 ° | 16.3 0 ° | 16.8 0 ° | 17.6
dBi 5 ° | 16.4 5 ° | 16.8 5 ° | 16.2 5 ° | 16.8 5 ° | 17.4
10 ° | 16.5 10 ° | 16.7 10 ° | 16.2 10 ° | 16.9 10 ° | 17.1
Beamwidth, Horizontal ±1.8 ±1.5 ±2.6 ±2.7 ±5
Tolerance, degrees
Beamwidth, Vertical ±0.4 ±0.2 ±0.6 ±0.6 ±0.6
Tolerance, degrees
USLS, beampeak to 20° 18 18 18 18 17
above beampeak, dB
Front-to-Back Total Power at 24 27 23 25 27
180° ± 30°, dB
CPR at Boresight, dB 18 15 19 18 17
CPR at Sector, dB 8 9 7 4 7
Material Specifications
Radome Material ASA, UV stabilized
Mechanical Specifications
Page 4 of 5
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 17, 2020
CV3PX310R1
Wind Loading at Velocity, frontal 1,237.0 N @ 150 km/h | 278.1 lbf @ 150 km/h
Wind Loading at Velocity, lateral 107.5 lbf @ 150 km/h | 478.0 N @ 150 km/h
Wind Speed, maximum 200 km/h | 124.274 mph
Packaging and Weights
Width, packed 420 mm | 16.535 in
Depth, packed 320 mm | 12.598 in
Length, packed 2720 mm | 107.087 in
Net Weight, without mounting kit 33 kg | 72.752 lb
Weight, gross 50 kg | 110.231 lb
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Included Products
T-029-GL-E — Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (60-115mm) OD round members for panel antennas. Includes 2 clamp sets.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 5 of 5
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 17, 2020
