Scribd
Upload
82 views1 page

Caracteristicas PC2Jamma

The PC2JAMMA board converts signals from a PC keyboard to arcade joystick signals and supports CGA monitors for playing MAME games on a PC. It requires installing all necessary software and drivers yourself. The board does not convert VGA to CGA, so you may need an additional driver to synchronize video signals on non-CGA monitors. It connects via a standard JAMMA connector and parallel port to function.

Uploaded by

alberto cansado arnelas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
82 views1 page

Caracteristicas PC2Jamma

The PC2JAMMA board converts signals from a PC keyboard to arcade joystick signals and supports CGA monitors for playing MAME games on a PC. It requires installing all necessary software and drivers yourself. The board does not convert VGA to CGA, so you may need an additional driver to synchronize video signals on non-CGA monitors. It connects via a standard JAMMA connector and parallel port to function.

Uploaded by

alberto cansado arnelas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PC2JAMMA board is designed

for converting the signals of PC K4: RESET


keyboard to arcade joystick and (Game reset: reset the game to initial menu)
supporting standard CGA K5: MENU
(RGB) monitor. It only works with (Game menu: reset to game selecting menu)
DOS version MAME games, you have
to install all required software and PC2JAMMA CONNECTION DIAGRAM
PARTS SIDE SOLDER SIDE
drivers for your PC by yourself. We
GND 1 GND
don't provide any driver either software. GND 2 GND
+5V 3 +5V
+5V 4 +5V
PC2JAMMA does not have the function 5
+12V 6 +12V
to convert VGA to CGA, if you have a 7
non synchronized screen after installing 8
9
it, then you might need to download a (+) SPEAKER 10 SPEAKER (-)
11
driver called arcmon.sys to synchronize
VIDEO RED 12 VIDEO GREEN
the video signal. VIDEO BLUE 13 SYNC.
VIDEO GND 14 SELECT MENU
1P SW6 15 2P SW6
K1: SYSTEM ENTER COIN A 16 COIN B
1P START 17 2P START
(System validation: for SYSTEM SERVICE) 1P UP 18 2P UP
K2: SYSTEM SERVICE 1P DOWN 19 2P DOWN
1P LEFT 20 2P LEFT
(System setting: for JAMMA Standard, user is 1P RIGHT 21 2P RIGHT
1P SW1 22 2P SW1
recommended to use default setting for the
1P SW2 23 2P SW2
default has been adjusted) 1P SW3 24 2P SW3
1P SW4 25 2P SW4
K3: TEST 1P SW5 26 2P SW5
(Game setting: set the game difficulty, user is GND 27 GND
GND 28 GND
recommended to use default setting for the
default has been adjusted)

connect to audio output of mother board

Blue wire: DC+5V


Yellow wire: DC+12V

connect to parallel port


of mother board

connect to VGA adaptor


of mother board

standard JAMMA connector

You might also like