Sheet No.
: 2419P- K
Issued Date : Jan. 2023
CMP PEELABLE COAT
(CMP P C)
PRODUCT DESCRIPTION
CMP PEELABLE COAT, is a single component, spray applied, water based coating direct application over
coated substrates and non-ferrous substrates.
And It gives more safe & Eco friendly working condition.
PRODUCT INFORMATION
Recommend Use As temporary protection of coated substrates and non-ferrous substrates
Color Blue
Solids by Volume 43% ± 2 (Test Method : ISO-3233)
VOC 40 g/ℓ (Korea Clean Air Conservation Act)
Coverage(Theoretical) 4.3 ㎡/ℓ [0.23 ℓ/㎡] at D.F.T 100㎛
75 - 100 ㎛ (Touch-up by roller & brush)
Dry Film Thickness
100 - 125 ㎛ (Spray by airless sprayer)
Over coating interval with recommended top coat
Drying time of peelable coat Over coating interval
Drying Time (at 100㎛) Temp. Touch Dry Peel Time Minimum Maximum
& Over coating interval 5℃ 40min. 2.5 hrs. 3 day -
15℃ 30min. 2 hrs. 2 day -
25℃ 20min. 1.5 hrs. 2 day -
40℃ 10min. 1 hrs. 1 day -
Method of Application Airless spray, Brush, Roller
Mixing : This material is a one component coating
so it should be always mixed thoroughly with
power agitator before application
Mix Ratio : Not applicable
Condition of Application Temperature : Minimum 5 ℃
Humidity : Maximum 85 % R. H.
For Airless spray ;
Tip No. : GRACO 515, 617, 719
Paint output pressure : 10.7 – 13.8 MPa
CMP PEELABLE COAT can be applied directly over coated steel and
other non-ferrous substrate
SYSTEMS COMPATIBILITY
CMP PEELABLE COAT can be applied directly over the approved type.
(Approved type: Urethane finish)
THINNER Fresh water
Packaging One pack product
The information given in this sheet is effective at the date shown above and subject to revision from time to time without notice.
