SUN ROOF - POWER
1994 Volvo 960
1994 ACCESSORIES/SAFETY EQUIPMENT
Volvo Power Sun Roof
960
DESCRIPTION & OPERATION
Vehicles may be equipped with a manual or power-operated sun
roof. If battery voltage is lost or interrupted, power sun roof can be
operated manually.
DIAGNOSIS & TESTING
NOTE: Power sun roof diagnosis and testing is not supplied by
manufacturer.
ADJUSTMENT
Front edge of sun roof should be 0-.06" (0-1.5 mm) below car
roof. Rear edge of sun roof should be 0-.04" (0-1.0 mm) above edge of
roof. Sun roof has no adjusting screws.
REMOVAL & INSTALLATION
CONTROL MODULE
Removal & Installation
Close sun roof. Remove roof light panel, consisting of light
glass, retaining screws and connector. Remove control module screw.
See Fig. 1. Pry control module straight down and forward. Disconnect
inner connector and remove control module. To install, reverse removal
procedure. Ensure 2 White markings are correctly positioned. See
Fig. 1.
Fig. 1: Removing & Installing Control Module
Courtesy of Volvo Cars of North America
SUN ROOF
Removal & Installation
1) Open sun roof to ventilation position. Working from
outside vehicle and from rear of sun roof, push down sun roof
headlining with a finger and, using a bent piece of wire, unhook
retaining springs on both sides.
2) Working from inside vehicle, pull down headlining at rear
of sun roof to allow enough space to slide sun roof headlining below
gutter rail. At same time, slide sun roof to rear to release catches
in front. Do not pull sun roof to far to rear or it may be difficult
to remove.
3) Unhook spring retaining brackets from sun roof. Remove sun
roof retaining screws. Remove sun roof. To install, reverse removal
procedure.
Fig. 2: Removing Sun Roof Motor
Courtesy of Volvo Cars of North America
Fig. 3: Positioning Sun Roof Hatch Mechanism
Courtesy of Volvo Cars of North America
WIRING DIAGRAM
Fig. 4: Power Sun Roof Wiring Diagram (960)
