Anabond® Technical Data Sheet
April , 2012
Anabond 697 Total pages 2
Product Description Typical Properties of Uncured
Material
Anabond 697 exhibits the following product
characteristics. Specific gravity@ RT 0.91-0.97
Flash point See MSDS
Technology Solvent based
Viscosity @ 25ºC,cps 400-800
Chemical Type Rubber
Colour Reddish brown Solid Content, (%) 31-37
Viscosity Low
Application Sealing Typical Properties of Cured Material
Temperature Vs pressure resistance
Anabond 697 is a synthetic rubber based brush on
The graph below shows pressure resistance
sealant typically developed for use as an adhesive
variance with temperature and tested according to
cum coating compound for rubber gasket in auto Anabond Test Method.
mobile engines, sealing of radiator hose joints. The
product remains tacky and elastic permanently. Its
excellent resistance to fuels and oils permits its use
on fuel line and lubrication line connections. Since
the product remains semi-cured it permits easy
disassembly of components.
General Information
This Product is not recommended for use in pure For safe handling information on this product,
oxygen and/or oxygen rich systems and should not consult the Material Safety Data Sheet (MSDS).
be selected as sealant for chlorine or other strong Optimal storage: At or below 25ºC. Greater
than 25°C can adversely affect product
oxidizing materials
properties.
Anabond is a Registered Trademark | ed. 1-10042012/847323562537 6971 Page 1 of 2
Directions for use
Material removed from containers may be
1. For high strength structural bonds,
contaminated during use. Do not return product to
remove surface contaminants such as the original container.
paint, oxide films, oils, dust, mold release
Shelf life and Packing
agents etc.
2. Use gloves to minimize skin contact. DO Six months from the date of manufacture and
packing in 500g
NOT use solvents for cleaning hands.
3. For maximum bond strength apply Disclaimer
sealant evenly to both surfaces to be
The data contained herein are furnished for
joined. information only and are believed to be
4. Keep parts from moving during cure. reliable. We cannot assume responsibility for the
results obtained by others over whose methods we
Contact pressure is necessary have no control. It is the user's responsibility to
determine suitability for the user's purpose of any
5. For a permanent bond apply a medium production methods mentioned herein and to adopt
such precautions as may be advisable for the
coat to both surfaces. Allow to dry 1-2
protection of property and of persons against any
minutes before bonding together. For hazards that may be involved in the handling and
use thereof.
porous surfaces, bond them while they
are slightly wet.
For product information contact:
6. Excessive uncured sealant can be
cleaned up with Ketone type solvents. Anabond Limited
36, Type II, Dr. VSI Estate,
Thiruvanmiyur,
Chennai 600041 India
Storage Ph: +91 (44) 23460041/42/43
Fax: +91 (44) 2346 0048
The product is classified as flammable and e-mail: marketing@anabond.com
must be stored in an appropriate manner in web: www.anabond.com
compliance with relevant regulations. Do not
store near oxidizing agents or combustible
materials. Store product in the unopened
container in a dry location. Storage
information may also be indicated on product
container labeling.
Anabond is a Registered Trademark | ed. 1-10042012/847323562537 6971 Page 2 of 2
