Equipment Hydrostatic Drive Diesel/LPG Truck

5,000 lbs. Capacity

H25

392 Series
Hallmarks
Trucks tailored perfectly to the operator. Designed creates a super-tough cage structure designed to specific application requirements via laptop computer.
to minimize fatigue, ensure safe operation, deliver maximum operator protection and safety. An auto-diagnosis function makes for uncomplicated
promote a healthy work environment and optimize Vastly reduced vehicle lost load/front overhang and troubleshooting procedures.
productivity. Highly cost effective trucks, unmatched curb-weight result in unmatched truck stability,

·· ··
Safety first Optional equipment in operating· efficiency due to low fuel consumption, performance and efficiency. Masts and tilt cylinders
Outstanding base and residual capacities Single pedal operation with armrest mounted directional controls minimal service requirements and outstanding Exclusive standard seam-welded belly-pan Outstanding base and residual truck capacities are

·· ··
Three separate braking systems Integral side-shift performance, contributing to a healthier environment contributes to additional chassis strength/rigidity while realized through the innovative design of the truck
due to significantly lower noise and engine emissions. protecting all components located within the chassis frame/overhead guard and the mast and tilt cylinder
Superb operator visibility Aux. hydraulic circuits
confines.

·· ··
Quiet operation Partial to full cab enclosures mounting points.
Excellent weight distribution and long wheelbase chassis Cab heater with pollen filter Operator compartment Exclusive overhead mounted tilt cylinders dramati-
Engine and drive system

··
High degree of steering accuracy Air conditioning with pollen filter Designed to satisfy the most stringent standards of cally reduce load torsion forces at the mast mounting
workplace ergonomics. Low driver step height and Exclusive Linde-built dual hydrostatic direct wheel points. Mast and tilt cylinders are shock-mounted
Wiper/washer system spacious foot-well ensure easy on/off access. A drives, without gear reduction assemblies, deliver via high-density neoprene isolator bushings. All

·· ··
Standard equipment Roof blind, clipboard and cab light spacious cabin area yields plenty of room for unmatched vehicle efficiency, response and control. mounting points are absolutely maintenance free.
Three-way adjustable full suspension bucket seat Custom truck lighting maximum operator comfort. No clutches, differential or brakes required for An exclusive internally mounted hose reel simplifies

·· ··
Linde patented twin-pedal directional controls Rear-view mirrors Exclusive Linde Load Control (LLC) provides day-to-day operation in even the harshest environ- the routing of all hydraulic lines through the mast
Adjustable steering wheel angle/height Back-up alarm precision control of all mast functions via adjustable
ments. Drive system perfected and proven durable in resulting in exceptional visibility for the driver. Clean

·· ··
On-demand hydrostatic power steering Warning light (Amber) armrest integral joysticks. countless extreme-duty off-road construction and simple hose routing results in vastly increased
Combustion air pre-cleaner (LP/Diesel) Custom paint Exclusive Linde twin-pedal directional control boostsmachinery applications. service/repair efficiencies in the after-market.

·· ·
Engine systems display panel (Glare free) Catalytic muffler (Diesel) working speed and efficiency by reducing the time Exclusive modern overhead-cam VW Diesel/LP
Tilt “memory” positioning required to change travel direction and speed. engine technology delivers unmatched fuel economy, Brake systems
Adjustable driver armrest with integral joystick hydraulic controls
Exclusive shock-mounted axles, mast, tilt cylinders, as well as super-low EPA compliant engine exhaust Exclusive no-wear three-way braking is

··
Low fuel level indicator and alarm (Diesel) chassis, hydraulic controls and multi-adjustable driver
and noise emissions.
Storage box and cup holder provided as standard equipment. The hydrostatic
bucket seat guarantee a superior ride on any surface.

··
Catalytic muffler (LP models) drive system features full-time dynamic braking
Excellent visibility in all directions, enhanced by Electrical system by simply releasing foot pressure on either the
Operator access grip placing the trucks instruments display in a non-glareExclusive Linde Truck Control (LTC) for traction and forward or reverse directional control pedals.

·
LBR module mounted inside the overhead guard. all hydraulic functions delivers pinpoint accurate Truck parking brake utilizes wet-disc design and
Linde Lift Truck Corporation
Headlights control of all truck travel and work functions via operates maintenance free. The wet-disc brakes
2450 West 5th North Street
ANSI CLASSIFICATION: Standard truck meets all applicable mandatory requirements of ANSI/ASME B56.1 standards for powered industrial trucks. Summerville, SC 29484 Chassis microprocessor based solid-state control module. are also automatically engaged when the engine
NOTE: Performance data may vary due to motor and system efficiency tolerances. The performance depicted represents nominal values obtained under typical
operating conditions. Metric dimensions are in millimeters unless otherwise specified. All metric dimensions are not direct equivalent s due to rounding data. The (843) 875-8000 Exclusive integral frame/overhead guard construction All operating parameters are adjustable to match is shut down for maximum safety.
descriptions and specifications included on this data sheet were in effect at the time of printing. Linde Lift Truck Corporation reserves the right to make E-mail:trucksales@lindelifttruck.com
improvements and changes in specification or design without notice and without incurring obligation. Please check with your authorized Linde dealer for
information on possible updates or revisions. Web Site: http://www.lindelifttruck.com
01/04/5M
Manufacturers Data and Design Characteristics
January 2004
1.0 Manufacturer Linde Linde
1.1 Model designation H25D H25T
1.2 Operation Rider seated Rider seated
Characteristics

1.3 Power unit: Diesel, Gasoline, LPG Diesel LPG

1.4 Load capacity Q lbs (kg) 5,0001 (2,500) 1 5,0001 (2,500)1
1.5 Load center c in (mm) 24 (500) 24 (500)
1.6 Axle center to fork face x in (mm) 15.35 (390) 15.35 (390)
1.7 Wheelbase Y in (mm) 75 (1,905) 75 (1,905)
2.0 Service weight lbs (kg) 7,882 3,575 7,840 (3,556)
2.1 Axle load with load, front/rear lbs (kg) 11,400/1,481 (5,382/693) 11,323/1,516 (5,347/709)
Weight

2.2 Axle load without load, front/rear lbs (kg) 3,779/4,103 (1,714/1,861) 3,702/4,138 (1,679/1,877)
3.0 Tires, front/rear (SE superelastic, P=pneumatic) P P
3.1 Tire size, front 23x9 - 10/16PR-IC402 23x9 - 10/16PR-IC402
Wheels and Tires

3.2 Tire size, rear 23x9 - 10/16PR-IC402 23x9 - 10/16PR-IC402 +

Capacity Information H25D/T with 23 x 9 - 10 SE Tires & Triple Mast.
3.3 Wheels, number front/rear (x = driven) 2(4)x/23 2(4)x/23
3.4 Track width, front b10 in (mm) 38.3 (972) 38.3 (972)
3.5 Track width, rear b11 in (mm) 36.7 (932) 36.7 (932)
4.0 Mast/fork carriage tilt, forward/back a/b (o) 5 / 8.5 5 / 8.5
4.1 Height of mast lowered h1 in (mm) see mast table see mast table
4.2 Free lift h2 in (mm) see mast table see mast table
4.3 Lift h3 in (mm) see mast table see mast table
4.4 Height of mast extended h4 in (mm) see mast table see mast table
4.5 Height of overhead guard (cab) h6 in (mm) 85.57 (2,170)7 85.57 (2,170)7
+ w.o. integral sideshift
4.6 Height of operator seat h7 in (mm) 41.9 (1,065) 41.9 (1,065)
4.7 Towing pin height h10 in (mm) 25-26 (645-655) 25-26 (645-655) Contact manufacturer for additional downrating information.
Dimensions

4.8 Length to fork face l2 in (mm) 105.3 (2,675) 105.3 (2,675)

Mast Information H25D/T
4.9 Overall width b1/b2 in (mm) 46.454 (1,180)4 46.454 (1,180)4
h1 h3 h2
4.10 Fork dimensions s/e/l in (mm) 1.75x4x42 (45x100x1000) 1.75x4x42 (45x100x1000)
Collapsed Fork Free lift **
4.11 Carriage, width/class b3 in (mm) 45.3 II (1,150) 45.3 II (1,150)
Height Height *
4.12 Ground clearance, mast m1 in (mm) 4.29 (109) 4.29 (109)
4.13 Ground clearance, center of wheelbase m2 in (mm) 5.07 (129) 5.07 (129) Simple Masts 85 (2,154) 125.5 (3,187) 0
87 (2,204) 129.5 (3,289) 0
4.14 Turning radius Wa in (mm) 95.3 (2,420) 95.3 (2,420)
91 (2,304) 137.5 (3,492) 0
4.15 Min. aisle dimension in (mm) 111.0 5
(2,820)5 111.05 (2,820)5 97 (2,454) 149.0 (3,984) 0
5.0 Travel speed, with/without load mph (km/h) 13/13 (21/21) 13/13 (21/21)
h1 h3 h2
Performance

5.1 Lifting speed, with/without load fpm (m/s) 108/110 (0.55/0.56) 108/110 (0.55/0.56)
Collapsed Fork Free lift **
5.2 Lowerspeed, with/without load fpm (m/s) 110 / 110 (0.56 / 0.56) 110 / 110 (0.56 / 0.56)
Height Height *
5.3 Tractive force, with/without load (60 min. rating) lbs (N) 3,374/3,024 (15,010/13,451) 3,374/2,934 (15,010/13,051)
5.4 Climbing ability with/without load (30 min. rating) % 26/34 26/34 Dual Masts 85 (2,154) 126.5 (3,213) 59.5 (1,511)
87 (2,204) 130.5 (3,314) 61.5 (1,562)
6.0 Engine manufacturer/type VW/BEQ VW/BEF
91 (2,304) 138.5 (3,517) 65.5 (1,663)
6.1 Engine rated power to ISO 1585 hp (kw) 46 (35) 48 (36)
97 (2,454) 150.0 (3,810) 71.0 (1,803)
I/C Engine

6.2 Rated speed rpm (max) 2,600 2,600

6.3 Number of cylinders/displacement cid/l 4/115 (4/1,896) 4/121 (4/1,984) h1 h3 h2
6.4 Fuel tank cap. (diesel) gal (l) 10.5 (40) - Collapsed Fork Free lift **
7.0 Service/parking brake Type Wet-disc Wet-disc Height Height *
7.1 Battery voltage V 12V 12V Triple Masts 85 (2,154) 187.0 (4,749) 59.5 (1,511)
7.2 Type of transmission Hydrostatic Hydrostatic 87 (2,204) 193.0 (4,902) 61.5 (1,562)
Other

7.3 Working pressure for attachments psi (bar) 2,973 (3,190)6 (205 (220)6 2,973 (3,190)6 (205 (220)6 91 (2,304) 205.0 (5,207) 65.5 (1,663)
8.45 (32) 8.45 (32) 97 (2,454) 218.5 (5,549) 71.0 (1,803)
7.4 Oil flow for attachments gpm (l/min)
7.5 Noise level, at operator’s ear db (a) 73 73 * For Mast Overall Extended Height (OAH) Add 44”/(1118mm) ** w.o. LBR

1) With SE tires 2) Optional 6.50 - 10 dual tires, 23x9-10 SE or 23x10-12 SE 3) Figures in parentheses for twin tires 4) 59.3” (1,506 mm) for SE 6.50 - 10 twin tires, 61” (1,550 mm) for 6.50 - 10/14 PR twin tires
5) Add load length plus clearance 6) Pressure 3,190 psi (220 bar) for triple masts 7) + 2.0” (50MM) with top glass wiper