Scribd
Upload
12 views2 pages

Inspection

The document outlines the inspection procedure for seat belt occupant detection sensors in vehicles, detailing resistance measurement standards for both separate type and bench seat type front seat cushion pads. It specifies the required resistance values when the front passenger seat is occupied and not occupied. If the measured resistance does not meet the specified criteria, the occupant detection sensor must be replaced.

Uploaded by

aliubed01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views2 pages

Inspection

The document outlines the inspection procedure for seat belt occupant detection sensors in vehicles, detailing resistance measurement standards for both separate type and bench seat type front seat cushion pads. It specifies the required resistance values when the front passenger seat is occupied and not occupied. If the measured resistance does not meet the specified criteria, the occupant detection sensor must be replaced.

Uploaded by

aliubed01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

14/3/17, 10)44 am

SEAT BELT OCCUPANT DETECTION SENSOR INSPECTION

PROCEDURE

1.INSPECT SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION 71512S
SENSOR)

a. for Separate Seat Type:


Measure the resistance according to the value(s) in
the table below.
Standard Resistance:

Component without harness connected


*a (Separate Type Front Seat Cushion Pad
(Occupant Detection Sensor))

Tester Specified
Condition
Connection Condition
Front passenger
1-3 Below 100 Ω
seat occupied
Front passenger
1-3 seat not 10 kΩ or higher
occupied

If the result is not as specified, replace the separate type front seat cushion pad (occupant detection sensor).

b. for Bench Seat Type:


Measure the resistance according to the value(s) in
the table below.
Standard Resistance:

Component without harness connected


*a (Separate Type Front Seat Cushion Pad
(Occupant Detection Sensor))

Tester Specified
Condition
Connection Condition

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000LZAL.html Page 1 of 2
14/3/17, 10)44 am

1-2 Front passenger Below 100 Ω


seat occupied
Front passenger
1-2 seat not 10 kΩ or higher
occupied

If the result is not as specified, replace the separate type front seat cushion pad (occupant detection sensor).

https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000LZAL.html Page 2 of 2

You might also like