IPC PSU

FSP180-50LE
DESCRIPTION
FSP180-50LE is an industrial level of switching power
supply. The power supply comes to offer the total power
capacity up to 180 Watts, and uses unique active PFC
(Power Factor C orrection) circuit design with its high-load
electrical components, makes it to be perfectly used in an
industrial environment. In addition, with its full range of
input and output electrical features, the power supply is
ideally the best choice for server, workstation,
communication or any other automation applications to
use. The product also complies with the latest safety and SAFETY STANDARD APPAOVAL
EMC standards, which is perfectly to meet various
regulations worldwide.
APPLICATION
For standard, advanced server, NAS and industrial power OUTPUT SPECIFICATION
system. Hold up Time: 115V/60Hz 17mSec.
Minimum@100% Load,
FEATURES 230V/50Hz 17mSec.
Low Ripple & Noise Minimum,@100% Load
Output over voltage protection Ouput Voltage +3.3Vdc output : +3.7 Vdc
Short circuit protection on all outputs Regulation: minimum, + 4.5Vdc
Resettable power shut down maximum
INTERNAL 4 cm fan +5Vdc output : +5.7 Vdc
100% burn-in under high ambient temperature(50℃) minimum, + 6.5Vdc
Vacuum-impregnated transformer maximum
MTBF:100K hours at 25℃ +12Vdc output : +13.3 Vdc
100% Hi-pot tested minimum, + 15.6Vdc
Line input fuse protection maximum
Output Rise Time: 115V-rms/230V-rms 5V
20ms Maximum
W ATTAGE 115V-rms/230V-rms 12V
Wattage: 180W 20ms Maximum
Ripple & Noise: 3.3V:50mV p-p
DIMENSION 5V:50mV p-p
Dimension: 150mm(L) x 81.5mm(W) x 12V1:120mV p-p
40.5mm(H) -12V:120mV p-p
5Vsb:50mV p-p
PRODUCT HIGHLIGHT Short Circuit Protection: load < 0.1 Ohm
Efficiency Level: Non-80+
Altitude: 2000M ENVIRONMENTAL SPECIFICATION
PMBus: For standard, advanced server, TEMP.Range: Storage Temperature: -
NAS and industrial power 20°C to + 80℃
system. MTBF: The power supply have a
minimum predicted
INPUT SPECIFICATION MTBF(MIL-HDBK-217) of
Input Range: 90-264 Vac 100,000 hours of continuous
Input Frequency: 47-63 Hz operation at 25℃,
Input Current: 115V@ 4.0 Amps-rms maximum maximum-output load, and
230V@ 2.0 Amps-rms maximum nominal AC inout voltage

GENERAL SPECIFICATION
Effciency: 68%
Voltage -12V, +3.3V, +5V: ±5%
Regulation: -12V: ±10%
PWOK Delay Time: 500ms > PWOK > 100ms
*Output Voltage and C urrent Rating
+3.3V +5V +12V1 -12V +5Vsb
Ripple-Noise(R-P) mV 50mV 50mV 120mV 120mV 50mV
Regulation Load % ±5% ±5% ±5% ±10% ±5%
Output Max.(A) 14A 16A 14A 0.5A 2A
Output Min.(A) 0.3A 0.3A 1.5A 0A 0A
NOTES
5V, 3.3V, 12V, -12V Will have the regulation to 10% when all load take off.
The +3.3V and +5V total output shall not exceed 90 watts.
The total output shall not exceed 180 watts
MECHANICAL SPECIFICATION

This content is subject to change, please refer to specification for m ore detail.
FSP reserve the right to change the content without prior notice

Downloaded from Arrow.com.