Check contract document 226

Check client specification

Pre-Job meeting
Check Procedure & ITP
Pre-application,
Check work schedule 222
(13-35)
Check readyness of paint material & abrasive material (including the COA) 219
Walk through in site Check inspection equipment (datasheet, calibration, etc.)
Check blasting painting equipment (datasheet, calibration, etc.)
Check compressor cleanliness from oil or water contamination ASTM D 4285
Check air pressure compresor
Check steel rust grade material ISO 8501-1
Check sharp edge or weld imperfections ISO 8501-3
Pre-Surface Preparation
Check oil contamination on surface, by using UV torch light or water drop test
Check abrasive type and conductivity ISO 11276, ASTM D 4940
Check oil contamination in abrasive ASTM D 7393
Check environment condition ASTM E 337, ISO 8502-4
Check surface cleanliness, ISO 8501 book / SSPC VIS 1 book ISO 8501-1
Check surface profile by ISO comparator ISO 8503-3, ASTM D 4417 Method A
Check surface profile by replica tape ISO 8503-5, ASTM D 4417 Method C
Check surface profile by stylus ISO 8503-4, ASTM D 4417 Method B
Surface Preparation,
Check dust level ISO 8502-3
(4-5)
Check NaCl salt on steel surface ISO 8502-6 / ISO 8502-9
Check iron salt on stainless steel surface ISO 8502-1 Annex A
Application
Check sharp edge or weld imperfections ISO 8501-3
Check drawing and paint system
Check environment condition ASTM E 337 & ISO 8502-4
Check paint material & batch number
Check tip nozzle of the spray gun
Check air spray or airless type & pump ratio
Check mixing paint ratio, pot life, induction time (6-8)
Check type of thinner and amount to be used
Paint application,
Check stripe coat application
(9-11)
Check WFT of sprayed paint ISO 2808
Check coating thickness / DFT SSPC PA2, ISO 19840
Check interval coat of next coat
Check visual appearance condition after spray
Perform solvent rub test for Organic Coating ASTM D 5402
Perform MEK rub test for IOZ ASTM 4752
Check visual assesment for any defect
Check DFT total coat SSPC PA2, ISO 19840
Check holiday test NACE SP0188
Final inspection Perform adhesion test (pull off ) ISO 4624, ISO 16276-1, ASTM D 4541
Perform adhesion test (Xcut) ISO 16276-2, ASTM D3359 method A
Perform adhesion test (cross cut) ISO 2409, ISO 16276-2, ASTM D3359 method B
Check repair area if any
Daily inspection report
Post-application
Adhesion report
Salt test report
DFT check report
Reporting Holiday report ISO 12944-8
Punchlist report
Paint store audit
Completion report
Inspection release note report