Scribd
Upload
16 views1 page

SectionE 93

This document outlines the steps for removing components from a hydraulic pump/regulator, specifically detailing the withdrawal of various parts such as the feedback lever, pilot piston, and compensating rod. It includes references to figures for clarity on the components involved. The instructions are intended for maintenance or repair purposes.

Uploaded by

manoj mukundan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views1 page

SectionE 93

This document outlines the steps for removing components from a hydraulic pump/regulator, specifically detailing the withdrawal of various parts such as the feedback lever, pilot piston, and compensating rod. It includes references to figures for clarity on the components involved. The instructions are intended for maintenance or repair purposes.

Uploaded by

manoj mukundan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Section E - Hydraulics

Hydraulic Pump/Regulator
Regulator
Note: Piston case 40 can be removed by pressing
compensating rod 42 from the opposite side of regulator
body 1.

Fig 33.

9 Withdraw feedback lever 35.

35

Fig 34.

10 Remove lever 36 from pin 37 (in the regulator body)


leaving pin 37A in position on the lever.

11 Draw out pilot piston 38 and spool 39.

12 Withdraw piston case 40, compensating piston 41


and compensating rod 42.

E-87 9803/6540-4 E-87

You might also like