Scribd
Upload
17 views1 page

U UTP-LEDURIT-60 Se en

UTP LEDURIT 60 is a high-efficiency, rutile-coated stick electrode designed for wear-resistant claddings against mineral abrasion, suitable for applications like conveyor screws and digging teeth. It features excellent welding characteristics, easy slag removal, and a hardness of approximately 60 HRC. Recommended welding parameters and instructions are provided, emphasizing the importance of maintaining specific angles and amperage during the welding process.

Uploaded by

Bruno Y Luana Penkal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views1 page

U UTP-LEDURIT-60 Se en

UTP LEDURIT 60 is a high-efficiency, rutile-coated stick electrode designed for wear-resistant claddings against mineral abrasion, suitable for applications like conveyor screws and digging teeth. It features excellent welding characteristics, easy slag removal, and a hardness of approximately 60 HRC. Recommended welding parameters and instructions are provided, emphasizing the importance of maintaining specific angles and amperage during the welding process.

Uploaded by

Bruno Y Luana Penkal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

UTP LEDURIT 60

Rutile-coated high-efficiency stick electrode for


highly wear-resistant claddings against mineral abrasion

Classifications
DIN 8555 EN 14700
E 10-UM-60-GRZ E Fe14
Characteristics and field of use
UTP LEDURIT 60 is universally applicable on parts predominantly subject to grinding abrasion
combined with light impact, such as conveyor screws, digging teeth, sand pumps and mixer wings.
It is also suited as a final layer on tough-hard deposits (UTP DUR 600) or high Mn-steel (UTP
BMC).

UTP LEDURIT 60 has excellent welding characteristics and a very easy slag removal. The
homogeneous and finely-rippled seam surface does, for most applications, not require any finishing
by grinding.

Hardness of the pure weld metal: approx. 60 HRC


1st layer on steel with C = 0.15%: approx. 55 HRC
1st layer on high Mn-steel: approx. 52 HRC
Typical analysis in %
C Si Cr Fe
3.0 1.3 29.0 balance
Welding instruction
Keep an angle of 80-90° between plate and electrode, and keep a short arc. Preheating is in
general not necessary. On multipass-welds, a cushion layer with UTP 630 is recommended to
prevent hardening cracks in the weld deposit. Re-dry damp stick electrodes for 2 hours / 300°C.
Welding positions

Current type DC (+) / AC

Recommended welding parameters


Electrodes Ø x L [mm] 2.5 x 300 3.2 x 350 4.0 x 350 5.0 x 450*
Amperage [A] 50-80 90-120 120-150 150-200
*available on request

All information provided is based upon careful investigation and intensive research. 08/2015 Rev. 0
However, we do not assume any liability for correctness and information is subject to change without notice. www.voestalpine.com/welding

You might also like