Scribd
Upload
26 views3 pages

Inspection

The document outlines the inspection procedures for the Parking Assist Smart Parking Assist System, specifically addressing the C1112 Sensor Source Voltage issue. It emphasizes the importance of checking wiring, connectors, and power circuits for faults such as looseness, corrosion, or damage. The document provides steps for verifying repairs and ensuring the power circuit is functioning within specified voltage parameters.

Uploaded by

AN NGUYEN NGOC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views3 pages

Inspection

The document outlines the inspection procedures for the Parking Assist Smart Parking Assist System, specifically addressing the C1112 Sensor Source Voltage issue. It emphasizes the importance of checking wiring, connectors, and power circuits for faults such as looseness, corrosion, or damage. The document provides steps for verifying repairs and ensuring the power circuit is functioning within specified voltage parameters.

Uploaded by

AN NGUYEN NGOC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

2015 > D 2.

0 TCI-R > Parking Assist Smart Parking Assist System > C1112 Sensor Source Voltage > Wiring Inspection

Termminal & Connector Inspection


1. Many malfunctions in the electrical system are caused by poor harness(es) and terminal condition.
Faults can also becaused by interference from other electrical systems, and mechanical systems or
chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination,
deterioration, or damage.
3. Has a problem been found?
▶ Repair as necessary and then go to "Verification of Vehicle Repair" Procedure.
▶ Go to "Power Circuit Inspection" Procedure.

Power Circuit Inspection


■ Ignition power circuit Inspection
1. Ignition "ON" & Engine "OFF".
2. Disconnect the SPAS Control Module.
3. Measure the voltage between the power circuit of the SPAS control Module and the body ground.

Specification : approx. B+

4. Is the measured value within specifications?


1/3
2015 > D 2.0 TCI-R > Parking Assist Smart Parking Assist System > C1112 Sensor Source Voltage > Wiring Inspection

▶ Go to "Power Circuit Inspection" Procedure.


▶ Check 10A, IG1 fuse of the power circuits status.
▶ Check the open or short to ground of the power cirucit of the SPAS control
Module. And then go to "Verification of vehicle Repair" procedure.

■ Power Circuit Inspection


1. Ignition "ON" & Engine "OFF".
2. Disconnect the SPAS/PAS each other sensor connector.
3. Measure the voltage between the power circuit of the SPAS control Module and the body ground.

Specification : about 12V

2/3
2015 > D 2.0 TCI-R > Parking Assist Smart Parking Assist System > C1112 Sensor Source Voltage > Wiring Inspection

4. Is the measured value within specifications?


▶ Fault is intermittent caused by poor connection in SPAS ECU's connector or was
repaired and SPAS ECU memory was not cleared. Thoroughly check connectors for
looseness, poor connection, bending, corrosion, contamination, deterioration, or
damage. Repair or replace as necessary and then go to "Verification of Vehicle
Repair" procedure.
▶Check the open or short to ground of the power cirucit of the SPAS control
Module. And then go to "Verification of vehicle Repair" procedure.

3/3

You might also like