Scribd
Upload
259 views7 pages

Vga Cut Off

This document provides instructions for cutting off the VGA signal from a cable by locating the VSYNC cable, typically white or black in color. The cable is cut and stripped on both sides before being soldered to a relay cable. Electrical tape is used to cover the soldered connections and cut areas of the wire to avoid short circuits. The finished product involves connecting the relay cable to a relay.

Uploaded by

Dlanor Avadec
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
259 views7 pages

Vga Cut Off

This document provides instructions for cutting off the VGA signal from a cable by locating the VSYNC cable, typically white or black in color. The cable is cut and stripped on both sides before being soldered to a relay cable. Electrical tape is used to cover the soldered connections and cut areas of the wire to avoid short circuits. The finished product involves connecting the relay cable to a relay.

Uploaded by

Dlanor Avadec
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 7

VGA CUT OFF

Prepare Your VGA Cable that is need to be cut

Cut the outer part insulator of the cable using your familiar cutter. I use scissor

Remove the cut insulator


Now locate the VSYNC CABLE ,Most common Color is White sometimes color black depend
on the cable you have.

Now ready your stripper cutter strip both side of it.

VSIGNAL is been strip.


Closer look in stripping the cable.

Now after the cable is cut and strip. Prepare the cable that is going to use in relay timer

Vsync and relay cable connected


ready the tools need to solder both of them

The material I use in this simple project.

Now solder both end of it.


A closer look of finish soldered.

To avoid the short circuit cover the cut area with electrical tape.

The soldered area is electrically taped.


Now tape the whole cut wire to cover it.

closer look of taped wires.

the final part is to connect the relay cable to relay.


finish product.

You might also like