1
Back to Main Page
Julie - Universal Car Emulator Programs:
Renault without CAN........................................................................................................2
Renault without CAN old ECUs.......................................................................................2
Program Use
• Sirius 32 / Sirius 34 without CAN
• EMS 3132 / EMS 3134 without CAN
• 1.9 2.2 and 2.5 dCi without CAN
• Delphi DDCR
Renault without CAN
• 1.9 dTi 1 plug
and
Renault without CAN – old ECUs • 1.9 dTi 2 plugs
• 1.9 diesel DCU3
• 2.8 TD
• 1 plug with 24C02 memory
• Volvo S40 and V40 – 1.9 TD Bosch ECU
Wiring colour codes
The LED behavior
- no jumpers – diagnostic mode - it flashes every second
- adjusting to the ECU – flashing 0,1 sec
- after adjusting it lights constantly and blinks every other second
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
2
Back to Main Page
Renault without CAN
In Universal Julie Emulator
solder jumpers J2, J3, J4 and J5
Renault without CAN old ECUs
In Universal Julie Emulator
solder jumper J5
SIRIUS 32 / SIRIUS 34 without CAN
EMS 3132 / EMS 3134
1.9 2.2 and 2.5 dCi without CAN
Delphi DDCR
1.9 dTi 1 plug
1.9 dTi 2 plugs
1.9 diesel DCU3
2.8 TD
1 plug with 24C02 memory
Volvo S40 and V40 – 1.9TD (Bosch 0 281 001 906 ECU)
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
3
Back to Main Page
Renault without CAN
SIRIUS 32 without CAN
Find 29F200 or 29F400 flash
In the addresses from 4000 to 7FFF, find
all values 64 C7 or 54 D7 or B4 5C
and change these values and two units
before them into FF FF FF FF
Repeat it in the whole map from
4000 to 7FFF !!!
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
4
Back to Main Page
Renault without CAN
Connecting emulator to ECU
Take power and GND for the emulator
from the capacitor
Connect Code signal after desoldering a
333 resistor
If there is A82C250 CAN transducer
on the plate in the ECU, then the
emulator will not work in this ECU!!!
SIRIUS 34
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
5
Back to Main Page
Renault without CAN
Tested on SIRIUS 34 ECUs
S118301104 A
S118301104 B
S118301211 B
S118301211 C
S118301212 B
S118301213 B
S118301213 C
S118301216 B
Find 29F200 or 29F400 flash
In the addresses from 4000 to 7FFF, find
all values 64 C7 or 54 D7 or B4 5C
and change these values and two units
before them into FF FF FF FF
Repeat it in the whole map from 4000 to
7FFF !!!
Connecting emulator to ECU
Take power for the emulator from the capacitor at the flash
In order to start the starter you need to join two pins of starter's relay!
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
6
Back to Main Page
Renault without CAN
EMS 3132
Find 29F200 or 29F400 flash
In the addresses from 4000 to 7FFF, find all values
64 C7 or 54 D7 or B4 5C
and change these values and two units before them
into FF FF FF FF
Repeat it in the whole map from 4000 to 7FFF !!!
Take power for the emulator from the capacitor at the flash.
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
7
Back to Main Page
Renault without CAN
Connect green wire as pictured after
unsoldering 333 resistor and connect it
to the point which leads to the processor.
EMS 3134
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
8
Back to Main Page
Renault without CAN
Tested on EMS 3134 ECUs
S118301120 B
S118301124 A
Find 29F400 flash
In the addresses from 4000 to 7FFF, find all values
64 C7 or 54 D7 or B4 5C
and change these values and two units before them
into FF FF FF FF
Repeat it in the whole map from 4000 to 7FFF !!!
Connect green wire as pictured to 88 pin and cut it off from wiring.
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
9
Back to Main Page
Renault without CAN
1.9 2.2 and 2.5 dCi without CAN
EDC15 - old
EDC15 - new EDC15 - new v2
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
10
Back to Main Page
Renault without CAN
In 5P08C3 memory
in the addresses:
003E 003F 0040 0041
and
0044 0045 0046 0047
change these values into FF
If there are VIN number
in memory content
use Renault with CAN ver 1 program
In ECU, solder immo line (code) of
emulator to the point as pictured
Take power for the emulator from the
capacitor on the ECU plate
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
11
Back to Main Page
Renault without CAN
Unsolder 334 resistor
Turn on the ignition for 30 seconds,then turn it off for 30 seconds and repeat the procedure a
few times
DDCR
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
12
Back to Main Page
Renault without CAN
Car without tachometer
Replace 25080 content and connect emulator.
10 pin of processor is immo line as pictured, which must be raised.
Take power from the capacitor at the memory.
Code injectors and settings with Clip or Launch.
ECU HOM8200334540
Use Julie as Renault without CAN program. Solder jumpers J2, J3, J4, and J5
Tested on:
Suzuki Jimny 1.5 diesel 2004
Nissan Almera 1.5 diesel 2004
1.9 dTi 1 plug
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
13
Back to Main Page
Renault without CAN
Connecting emulator to ECU
Connect the immo line of emulator to
pin 59 of ECU.
Connect GND and ACC to diode in the
ECU.
Bend pin 59 in ECU socket
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
14
Back to Main Page
Renault without CAN
1.9 dTi 2 plugs
In the addresses from 174 to 177 and
1B7 to 1BA
change these values into FF FF FF FF in
24C04 memory
Connecting emulator to ECU
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
15
Back to Main Page
Renault without CAN
Cut off pin 15 from wiring!!!
1.9 diesel DCU3
Renault Kangoo 1.9 Diesel 2001
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
16
Back to Main Page
Renault without CAN
In addresses from 02 to 05 and 82 to 85
change these values into 00 00 FF FF in
95080 memory
Connecting emulator to ECU
Pin 20 must be bent in socket or cut off from the car wiring.
Connecting emulator to ECU
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
17
Back to Main Page
Renault without CAN
2.8 TD
(Renault Mascott)
In addresses from 040 to 1FF change these values into FF in 24C16 memory
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
18
Back to Main Page
Renault without CAN
Connecting emulator to ECU
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
19
Back to Main Page
Renault without CAN
1 plug with 24C02 memory
(Renault Laguna)
Cut off pin 50 from ECU!!!
In addresses from 05A to 05F and
from 0F2 to 0F7 change these values
into FF in 24C02 memory
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
20
Back to Main Page
Renault without CAN
Volvo S40 and V40 – 1.9TD (Bosch 0 281 001 906 ECU)
MSA 15.5-5.40
In addresses from 03F to 041 and from
054 to 057
change these values into 00 00 FF FF in
24C02 memory
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
21
Back to Main Page
Warning!!!
Due to possible construction changes of cars, check signals with multimeter in the ECU plug.
All rights reserved.
Unauthorized copying, hiring, lending, public performance will be punished!
We state that we are the only authentic authors of this manual. We possess copyright of this
publication. Any trials of unauthorized copying, hiring, quoting prohibited!!! Both service and
advertisement constitute copyright and they are the subject to the protection in accordance with the
Act from 4th Feb. 1994 on Copyright and Related Laws (Statute Book no. 24 position 93) and
protection on the basis of the Act from 8th June 1993 on combating an unfair competition (Statute
Book no. 47 position 211)
www.carlabimmo.com
Last updated 13.03.2018
You can buy our products and obtain technical support from our distributor. Find a distributor
near you by clicking on the link: www.carlabimmo.com/our-partners
