Guitar amplifier schematic

DMOs TDA7294 integrated amplifier guitar amp used for a variety of powerful sound, the tone control circuit TL071, TL072, TL074 op-amp ICs used Voice in the int

It has a guitar overdrive effect, 2n5088 transistor, 741 opamp, two potentiometers and some more components .. Tested circuit.

This is a PCB LAYOUT MASTER STEREO PRE-AMPLIFIER. Every amplifier needs this type of pre-amplifier to produce good sound

In this project article for audioXpress, the author shares his guitar tube amplifier, a simple, low-wattage, that any DIYer can easily build. Costas Sarris believes in building simple tube amplifier designs, with simple circuits that he found to work better, particularly when the electric signals carry music information, because the signal distortion is easily handled. This article was originally published in audioXpress, June 2015.

In an amongst the guitar building I decided to break out the soldering iron to build an overdrive pedal – as light relief. I had stumbled across the “Valvecaster” schematic and la…

Hello Electronic DIY'ers, on this occasion I will share a PCB Layout file for Marshal V.120PA power amplifier. Where this power amplifi...

This the guitar power amplifier circuit, using a single-rail power supply of about 60V and capacitor-coupling to the speaker (s). The advan...

This is a design schematic Class A power amplifier . This is a close as possible in operating parameter the Under Classes is class B , to...

This is a Guitar Amplifier Using TL071 IC. this is a good quality amplifier for guitar. It’s also easy to make It’s run with 9 volts. We can see in electric guitar with sound control there used one 9 volt battery. that buttery can be used in this circuit. Normally in acoustic guitar, there has no electric system. We can convert acoustic to electric using this type of circuit.