the final project of 微算機原理與應用 course in NCKU 2019.1

This repository contains Puneet Bansal's contribution to IOT Embedded Firmware Final Project ( Spring 2019).

A C-library for the HC SR-04 ultrasonic sensor

A project to create an LCD board computer for Audi 80 using an Arduino Mega.

A small elevator control system that runs on ATMEL's 8-bit microcontroller.

I2C controlled LCD driver for Raspberry Pi (bcm2835 library based).

Confetti Demo is an embedded C program that showcases the core features of my G8RTOS implementation.

Basic routines for interfacing a HD44780-based text LCD display

A VT52 client with BLE keyboard and LCD display.

RPI3-based home entertainment system

Computer graphics library for 128x64 LCDs (ST7920 controller).

Drivers for 7-segment display on STM32 using CMSIS Libraries

N108 is a full bare-metal real-time operating system for the TM4C123 chip, written from scratch.

Electronics learning bits

FFT on audio captured by a mic and displayed on the LCD

u8g2 Monochrome LCD Library for STE2007 controller

Design and prototyping of a parking sensor based on a microcontroller that manages four ultrasonic distance sensors and a temperature sensor, and according to these drives an LCD display and a buzzer. An FPGA allows to record all the measures and to send them to a PC if there is a request.

ATmega32 ADC Driver

This project uses the low-power STM32F446RE microcontroller with a keypad, LCD, ADC, and UART integration. It features RTOS-based task scheduling and efficient data sampling and transmission. The system offers a cost-effective, high-performance solution for embedded applications.