By arranging the particle first banana orbits to pass near a distant detector, the light ion beam probe (LIBP) utilizes orbital deflection to probe internal fields and field fluctuations. The LIBP technique takes advantage of (1) the in situ, known source of fast ions created by beam-injected neutral particles that naturally ionize near the plasma edge and (2) various commonly available diagnostics as its detector. These born trapped particles can traverse the plasma core on their inner banana leg before returning to the plasma edge. Orbital displacements (the forces on fast ions) caused by internal instabilities or edge perturbing fields appear as modulated signal at an edge detector. Adjustments in the q-profile and plasma shape that determine the first orbit, as well as the relative position of the source and detector, enable studies under a wide variety of plasma conditions. This diagnostic technique can be used to probe the impact on fast ions of various instabilities, e.g., Alfvén eigenmodes (AEs) and neoclassical tearing modes, and of externally imposed 3D fields, e.g., magnetic perturbations. To date, displacements by AEs and by externally applied resonant magnetic perturbation fields have been measured using a fast ion loss detector. Comparisons with simulations are shown. In addition, nonlinear interactions between fast ions and independent AE waves are revealed by this technique.

The initial experiments on off-axis neutral beam injection into high noninductive current fraction (f NI), high normalized pressure (β N) discharges in DIII-D [J. L. Luxon, Fusion Sci. Technol. 48, 828 (2005)] have demonstrated changes in the plasma profiles that increase the limits to plasma pressure from ideal low-n instabilities. The current profile is broadened and the minimum value of the safety factor (q min) can be maintained above 2 where the profile of the thermal component of the plasma pressure is found to be broader. The off-axis neutral beam injection results in a broadening of the fast-ion pressure profile. Confinement of the thermal component of the plasma is consistent with the IPB98(y,2) scaling, but global confinement with q min > 2 is below the ITER-89P scaling, apparently as a result of enhanced transport of fast ions. A 0-D model is used to examine the parameter space for f NI = 1 operation and project the requirements for high performance steady-state discharges. Fully noninductive solutions are found with 4 < β N < 5 and bootstrap current fraction near 0.5 for a weak shear safety factor profile. A 1-D model is used to show that a f NI = 1 discharge at the top of this range of β N that is predicted stable to n = 1, 2, and 3 ideal MHD instabilities is accessible through further broadening of the current and pressure profiles with off-axis neutral beam injection and electron cyclotron current drive. © 2013 AIP Publishing LLC.

An energetic-particle (EP)-driven off-axis-fishbone-like mode (OFM) often triggers a resistive wall mode (RWM) in JT-60U and DIII-D devices, preventing long-duration high-βN discharges. In these experiments, the EPs are energetic ions (70-85 keV) injected by neutral beams to produce high-pressure plasmas. EP-driven bursting events reduce the EP density and the plasma rotation simultaneously. These changes are significant in high-βN low-rotation plasmas, where the RWM stability is predicted to be strongly influenced by the EP precession drift resonance and by the plasma rotation near the q = 2 surface (kinetic effects). Analysis of these effects on stability with a self-consistent perturbation to the mode structure using the MARS-K code showed that the impact of EP losses and rotation drop is sufficient to destabilize the RWM in low-rotation plasmas, when the plasma rotation normalized by Alfvén frequency is only a few tenths of a percent near the q = 2 surface. The OFM characteristics are very similar in JT-60U and DIII-D, including nonlinear mode evolution. The modes grow initially like a classical fishbone, and then the mode structure becomes strongly distorted. The dynamic response of the OFM to an applied n = 1 external field indicates that the mode retains its external kink character. These comparative studies suggest that an energetic particle-driven off-axis-fishbone-like mode is a new EP-driven branch of the external kink mode in wall-stabilized plasmas, analogous to the relationship of the classical fishbone branch to the internal kink mode. © 2011 American Institute of Physics.

Energy and pitch angle resolved measurements of escaping neutral beam ions (E ≈ 80 keV) have been made during DIII-D L-mode discharges with applied, slowly rotating, n = 2 magnetic perturbations. Data from separate scintillator detectors (FILDs) near and well below the plasma midplane show fast-ion losses correlated with the internal coil (I-coil) fields. The dominant fast-ion loss signals are observed to decay within one poloidal transit time after beam turn-off indicating they are primarily prompt loss orbits. Also, during application of the rotating I-coil fields, outboard midplane edge density and bremsstrahlung emission profiles exhibit a radial displacement of up to δR ≈ 1 cm. Beam deposition and full orbit modeling of these losses using M3D-C1 calculations of the perturbed kinetic profiles and fields reproduce many features of the measured losses. In particular, the predicted phase of the modulated loss signal with respect to the I-coil currents is in close agreement with FILD measurements as is the relative amplitudes of the modulated losses for the co and counter-current beam used in the experiment. These simulations show modifications to the beam ion birth profile and subsequent prompt loss due to changes in the edge density; however, the dominant factor causing modulation of the losses to the fast-ion loss detectors is the perturbed magnetic field (δB/B ≈ 10-3 in the plasma). Calculations indicate total prompt loss to the DIII-D wall can increase with application of the n = 2 perturbation by up to 7% for co-current injected beams and 3% for counter-current injected beams depending on phase of the perturbation relative to the injected beam. © 2014 IOP Publishing Ltd.

In the wall-stabilized high-β plasmas in JT-60U and DIII-D, interactions between energetic particle (EP) driven modes (EPdMs) and edge localized modes (ELMs) have been observed. The interaction between the EPdM and ELM are reproducibly observed. Many EP diagnostics indicate a strong correlation between the distorted waveform of the EPdM and the EP transport to the edge. The waveform distortion is composed of higher harmonics (n 2) and looks like a density snake near the plasma edge. According to statistical analyses, ELM triggering by the EPdMs requires a finite level of waveform distortion and pedestal recovery. ELM pacing by the EPdMs occurs when the repetition frequency of the EPdMs is higher than the natural ELM frequency. EPs transported by EPdMs are thought to contribute to change the edge stability. © 2013 IAEA, Vienna.

Recent EAST/DIII-D joint experiments on the high poloidal beta tokamak regime in DIII-D have demonstrated fully noninductive operation with an internal transport barrier (ITB) at large minor radius, at normalized fusion performance increased by 30% relative to earlier work (Politzer et al 2005 Nucl. Fusion 45 417). The advancement was enabled by improved understanding of the 'relaxation oscillations', previously attributed to repetitive ITB collapses, and of the fast ion behavior in this regime. It was found that the 'relaxation oscillations' are coupled core-edge modes amenable to wall-stabilization, and that fast ion losses which previously dictated a large plasma-wall separation to avoid wall over-heating, can be reduced to classical levels with sufficient plasma density. By using optimized waveforms of the plasma-wall separation and plasma density, fully noninductive plasmas have been sustained for long durations with excellent energy confinement quality, bootstrap fraction ≥80%, βN ≤ 4, βP ≥ 3, and βT ≥ 2%. These results bolster the applicability of the high poloidal beta tokamak regime toward the realization of a steady-state fusion reactor.

Measurements show fast ion losses correlated with applied three-dimensional (3D) fields in a variety of plasmas ranging from L-mode to resonant magnetic perturbation (RMP) edge localized mode (ELM) suppressed H-mode discharges. In DIII-D L-mode discharges with a slowly rotating n = 2 magnetic perturbation, scintillator detector loss signals synchronized with the applied fields are observed to decay within one poloidal transit time after beam turnoff indicating they arise predominantly from prompt loss orbits. Full orbit following using M3D-C1 calculations of the perturbed fields and kinetic profiles reproduce many features of the measured losses and points to the importance of the applied 3D field phase with respect to the beam injection location in determining the overall impact on prompt beam ion loss. Modeling of these results includes a self-consistent calculation of the 3D perturbed beam ion birth profiles and scrape-off-layer ionization, a factor found to be essential to reproducing the experimental measurements. Extension of the simulations to full slowing down timescales, including fueling and the effects of drag and pitch angle scattering, show the applied n = 3 RMPs in ELM suppressed H-mode plasmas can induce a significant loss of energetic particles from the core. With the applied n = 3 fields, up to 8.4% of the injected beam power is predicted to be lost, compared to 2.7% with axisymmetric fields only. These fast ions, originating from minor radii ρ > 0.7, are predicted to be primarily passing particles lost to the divertor region, consistent with wide field-of-view infrared periscope measurements of wall heating in n = 3 RMP ELM suppressed plasmas. Edge fast ion Dα (FIDA) measurements also confirm a large change in edge fast ion profile due to the n = 3 fields, where the effect was isolated by using short 50 ms RMP-off periods during which ELM suppression was maintained yet the fast ion profile was allowed to recover. The role of resonances between fast ion drift motion and the applied 3D fields in the context of selectively targeting regions of fast ion phase space is also discussed.