This mod changes out the old 8-bit controller and replaces it with an Arduino Pro-Micro w/MMjoy2 firmware and replaces the rudder potentiometer for a TLE5010 magnetoresistive sensor. The foot brake pots now have 10-bit res. and the rudder is set to 12-bit resolution. I had an extra TLE5010 alread…

Remove jitter from CH Products ProThrottle. Contribute to S7R4nG3/ch-jitter-kill development by creating an account on GitHub.

Posted in r/hoggit by u/Jagua62 • 13 points and 9 comments

Posted in r/hotas by u/TalorienBR • 92 points and 19 comments

The u/Mortisrose1 community on Reddit. Reddit gives you the best of the internet in one place.

Hi Guys,With the latest mmjoy, testing under Joy-tester:I have just noticed that both my X and Y axis, even after calibration,both of them, after a while, can not reach their maximum output.X axis value on the Joystick axes page:middle 2068low 380high 3696Y axis value on the Joystic…

After suffering a bit with the potentiometer of the rudder shaft I decided to apply a more definitive solution and install the TLE 5010 PCB in my 20 years around CH PRO PEDAL. It is working great and I hope it last more 10 years .

Add Buttons to Your X52-Pro Joystick With an Arduino Micro: I have a Saitek X52-Pro HOTAS setup which I use for Elite:Dangerous. It’s a fantastic joystick but it could do with just a few more buttons. Using an Arduino Micro you can extend this (or any other) joystick for any game that will support multiple…

This video shows how I upgraded my CH Pro Throttle USB with a Hall Effect Sensor. The CH fighterstick HE upgrade kit also available. This kit includes Roll, Pitch and Throttle units. Typo Error - The ending statement should be “ The DIY upgrade processes are completed.” :) Thanks for watching.

#DIY #Gamecontroller #joystick #MMJOY

Guide on how to DIY your Game or any other controller using MMJOY2 firmware and Arduino board (Leonardo and micro) This is 3 part video and this is part 3 (Step 3 and 4) On the hardware design (Step 3) On setting MMJOY2 firmware with specific function on analog axis, button function (various one for various purposes incl. simple push button, toggle switch, rotary switch, etc.)

A beginners guide to using the Arduino Joystick 2.0 Library, by MHeironimus

Github for Library https://github.com/MHeironimus/ArduinoJoystickLibrary

Files mentioned in video (Sketch + AVR Board Folder)

https://drive.google.com/drive/folders/1STL7BV-6psuA83jm13oz_1yqtiYGmwCt?usp=sharing

The Library will only work on MEGA32u4 boards, such as the Arduino Pro Micro or Leonardo, or a AT91SAM board like the Arduino Due.