Aaron Mascaro

Hi Percy, Thanks for the detailed response! I'm thinking external triggering with the GPIO will be my best bet at this point, but it would be a much cleaner solution if I could use multiple VP programs like you showed. Based on what I've seen so far, after a VP program finishes everything returns to the initial state (like the z-position, feedback settings etc.). Is there any way to set it up so that after I run the first VP program everything stays fixed (tip retracted, feedback off) until after...

Hi Percy, I'd like to do a measurement that requires some external hardware and I was wondering if there is a way to run python scripts inside of a VP operation? I need to do one complete measurement with the tip fixed at some lift-height and also need to talk to my hardware during this time. Is this possible currently? I could also do it manually with a python script, but I can't fgure out how to access the feedback and z-position from Pyremote. Is there any way I can do that as well? Thanks! A...

Problem solved! I just had to update the DSP code (after making the necessary changes...

I should add that we're on r4062, there were compatibility issues with the newer...

Hi Percy, We recently had a hard drive fail on our main computer, so we had to install...

Hi all, I encountered a strange error today, first the computer running GXSM crashed...

Hi again, I saw your post regarding different grid/scan sizes and wrote a Python...

Hi Percy, I'm using the Raster Probe feature and would like to do something like...