Lab

Lab

VHRD's electronics lab: soldering and rework gear, a CNC router, a pick-and-place machine and a reflow oven.

Main desk with two monitors, bench power supplies, an oscilloscope and a multimeter
FIG. 1The main desk

The lab has what a board needs from idea to test:

  • Measurement, soldering and rework equipment.
  • A CNC router.
  • A D600Plus pick and place machine.
  • A vapour reflow oven.
  • A stencil printer.
  • A spot welder.
  • More than 1300 electronic parts, collected over the years.

The projects built here are on the work page.

Workbench with screwdriver rack, hand tools and a stereo microscope
FIG. 2The workbench
Desktop pick-and-place machine next to shelves of component bins
FIG. 3Pick and place and the parts store
Assembled laser scanner machine on a workbench
FIG. 4The 3D laser scanner, built in the lab
Stencil printer with a steel stencil on a vacuum block, alignment pins and clamps on a perforated plate
FIG. 5The vacuum stencil printer
Close-up of a green circuit board with solder paste printed on a BGA footprint and the pads around it
FIG. 6Solder paste from the stencil printer, on a BGA footprint
Bench with an infrared IC heater, a rework station with its handpiece in a holder, and a set of wrenches
FIG. 7The reflow station: a T-962 infrared IC heater and a Quick TR1300A rework station
Microscope view of a fine-pitch board-to-board connector soldered onto a green circuit board
FIG. 8Reflowed in-house: a fine-pitch board-to-board connector
CNC router gantry with its spindle, ball screw, linear rails and cable carrier
FIG. 9The CNC router