Scribd
Upload
35 views1 page

CTB011

The document provides instructions for bleeding air from a vehicle's clutch system. It notes not to use power bleeders and to carefully monitor fluid levels. The procedure involves bleeding air first from the operating cylinder valve and then the bleed connector valve, pumping the clutch pedal while fluid is depressed and bleeding the line with the vehicle stationary.

Uploaded by

Mshibonium
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views1 page

CTB011

The document provides instructions for bleeding air from a vehicle's clutch system. It notes not to use power bleeders and to carefully monitor fluid levels. The procedure involves bleeding air first from the operating cylinder valve and then the bleed connector valve, pumping the clutch pedal while fluid is depressed and bleeding the line with the vehicle stationary.

Uploaded by

Mshibonium
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CTB011

11

CLUTCH BLEEDING PROCEDURE

NOTE: CAUTION:
Do not use a vacuum assist Carefully monitor fluid level in reservoir tank during bleeding operation.
or any other type of power Keep painted surface of body and other parts free of clutch fluid. lf a spill
bleeder on this system. Use occurs, wipe up immediately and wash the affected area with water.
will not purge all the air First bleed the air from the operating cylinder air bleed valve and then
from the system. from the bleed connector air bleed valve.

1 Connect a transparent vinyl tube and container to the air bleeder valve on the
clutch operating cylinder.
2 Fill reservoir tank with new clutch fluid
3 Depress and release the clutch pedal slowly and fully 15 times at an interval of 2
to 3 seconds.

4 With pedal DEPRESSED, continue the bleeding procedure


5 Push the lock pin (1) of the bleeding connector (2) into the locked position

CAUTION: Hold it to prevent releasing clutch tube from bleeding connector (2)
when fluid pressure is applied in the tube.

6 Slide clutch tube (1) in the direction of the arrow as shown, then bleed the air
from the tube. Dimension A: 5 mm (0.20 in)
7 Return clutch tube (1) and lock pin (2) to their original positions.
8 Release clutch pedal and wait for 5 seconds.
9 Repeat steps 2 to 8 until no bubbles are observed in the clutch fluid

You might also like