Scribd
Upload
53 views1 page

2101 JTAGLive Controller E

The document describes the JTAGLive boundary-scan controller. It has a compact single TAP connector for flexible board interfacing. It is compatible with various JTAG and boundary-scan standards. The controller has a programmable TAP voltage from 1.5V to 3.6V and TCK frequency up to 6MHz. It can be used for boundary-scan testing, programming FPGAs and small flash memories.

Uploaded by

gangavinodc123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
53 views1 page

2101 JTAGLive Controller E

The document describes the JTAGLive boundary-scan controller. It has a compact single TAP connector for flexible board interfacing. It is compatible with various JTAG and boundary-scan standards. The controller has a programmable TAP voltage from 1.5V to 3.6V and TCK frequency up to 6MHz. It can be used for boundary-scan testing, programming FPGAs and small flash memories.

Uploaded by

gangavinodc123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

JTAGLive controller TAP connector pin-out

Factsheet
JTAGLIVE BOUNDARY-SCAN CONTROLLER
Compact, portable controller for JTAG and boundary-scan applications

Key features

• Compact single TAP (Test Access Port) for flexible


board interfacing
• Fully Compatible with IEEE 1149.1, IEEE 1149.6,
IEEE 1149.4 and IEEE 1532 standards
• Fully programmable TAP voltage (1.5 V to 3.6 V)
• Up to 6MHz programmable TCK frequency USB
Powered (no external PSU needed)
• For boundary-scan /JTAG testing, PLD & FPGA
configuration and small-scale flash programming.
• JTAG Live and ProVision compatible
• Stylish contemporary design

Prompted by the steady growth in the use of The controller can be used equally for structural
JTAG/boundary-scan (IEEE Std 1149.1) devices within board testing or in-system device programming (ISP)
electronic design, the JTAG Live controller has been of CPLDs, flash memories etc.. Programmable output
developed to offer a truly low-cost, fully functional, levels of 1.5V to 3.6 volts make the JTAGLive controller
JTAG/boundary-scan interface - powered by USB. The compatible with all current and future logic families.
market for boundary-scan tools has evolved greatly Test clock frequency may also be programmed from
in recent years and JTAG/boundary-scan logic is now 1KHz to a brisk 6MHz allowing test applications to be
widely fitted as standard to all CPLD’s, most micropro- executed in a ‘snap’. This product represents a
cessors and many other large pin-count logic devices. significant breakthrough and puts boundary-scan
The JTAGLive controller offers the opportunity for all test within reach of many more would-be users.
engineers to gain experience with this valuable test
and debug technology. The JTAGLive controller is
compatible with all JTAG Technologies’ developer tools
such as JTAG ProVision, the free of charge JTAG Live
‘Buzz’ utility and also JTAG Live Studio.

2101-JTAGLive Controller-E-1000
© The JTAG Technologies logo and other trademarks designed with the symbol Recommended pinout
“®” are trademarks of JTAG Technologies registered in Europe and/or other countries.
JTAG Technologies reserves the right to change design and specifications without notice.

Making JTAG accessible www.jtaglive.com

You might also like