Little Doll bed
To print your pattern, you will need to set the printer scale at 100%.
Once you printed all the pages, you can check the pattern size accuracy by checking that the 1
INCH square on the pattern is EXACTLY 1 inch.
The seam allowance (1/4") is included in all the pattern pieces. All the measurements are in
inches.
You can use cotton, linen, or cotton linen blend to make the bed.
I do not recommend using thin or stretchy fabrics.
You will also need a bit of stuffing, a pencil or eraser pen and a ruler.
You do not need to print a pattern to make this bed, simply follow the instructions!
All measurements are in INCHES!
Cut out 2 rectangles:
One 9" by 5 and 1/2"
one 6" by 5 and 1/2"
Place the smaller rectangle Press the seam. Lay the Make 2 marks on the lining as
on the bigger one and stitch piece you just stitched on shown above.
the top edges together. another layer of fabric and
cut out the same shape.
Lay the 2 pieces together, Turn the piece inside out Bring the bottom edge toward the
right sides together and and press. Fold the open top and place it right where the
stitch them all around and seam is on the back.
edges toward in so that
leave an opening between
they are aligned with the
the 2 marks you just made.
rest of the seam.
Pin the 2 sides and stitch Using a pencil and a ruler, Using small amounts of stuffing,
them. draw 2 lines, one 2 and 1/4" stuff the top part.
below the top edge and the
other one 1 and 1/4" below the
first line.
You don’t need to stuff a lot. Place pins on the first line and Pin the second line and stitch it.
The stuffing thickness is less stitch it. Then stuff the space in
than 1 inch. between line 1 and 2, using
small amounts of stuffing too.
Use the ladder stitch Fold the top edge toward down and place it right above the bed
technique showed on page 3 top edge. Make a few hand stitches to secure the pillow in place
to close up the opening. on both sides. Et voila! What a cute little bed!.
How to ladder stitch?
To close up the dress gap, we are going to Make even, small stitches (around 1/4" wide)
use the ladder stitch. Please use matching that are on the edge of the seam and parallel to
thread and a sharp, thin needle. Poke the each other. Gently pull the thread to close the
needle through the edge of the seam. Sew opening Make a knot inside the seam and poke
from the right to the left side of the opening. the needle out a little further away from the
stitches.
If you post about the bed you made from my pattern, please credit me as the
designer of the pattern (pattern by: @manimina_studio). Thank you!
Check all our dolls PDF patterns in my etsy shop!
https://www.etsy.com/shop/manimina/
TERMS OF USE
This pattern is for personal use only. Please do not sell or redistribute this pattern in printed form
or electronically. I thank you for respecting my work and please send friends and fellow sewers a
link to purchase my pattern.
Yours, truly Emilie
Mani Mina Studio - New York
