R2 Trilobite
in
Trilobite means “three lobed” because if you look at a trilobite fossil (or indeed a
knitted trilobite fossil) its body is divided into three lengthways sections. Our trilobites
have been knitted still partially encased in rock.
You will need:
4 ply or sock wool in greys • toy stuffing
4 x double ended knitting needles (3mm) • tapestry needle • scissors
Pattern (Trilobite):
First we are going to make an embossed trilobite design on a flat rectangle of knitting. The design is
shown on the grid and instructions are written out in full below.
Cast on 21 stitches.
Row 11: p2, [k1, p1] x 6, k2, p2, k2, p1
Row 1: p – Row 12: k1, p2, k2, p2, [k1, p1] x 6, k2
Row 2: k4, p3, k1, p1, k12 Row 13: as row 11
Row 3: p10, [k1, p1] x 2, k4, p3 Row 14: k1, p2, k2, p15, k1
Row 4: k2, p5, [k1, p1] x 3, k8 Row 15: p14, k2, p2, k2, p1
Row 5: p6, [k1, p1] x 4, k5, p2
Row 6: k1, p6, [k1, p1] x 4, k6 Rows 16 to 23: as rows 8 to 1 – please note
Row 7: p4, [k1, p1] x 5, k6, p1 that the order of rows is reversed to create a
Row 8: k1, p3, k1, p2, [k1, p1] x 6, k2 symmetrical pattern.
Row 9: p1, k15, p2, k2, p1
Row 10: k1, p2, k2, p2, k14 Cast off.
w w w.o d d k n i t .c o m/ p a tt e r ns / fo s s i l s/ t r i l o b i t e .h t m l
Pattern (Rock):
Pick up and knit 60 stitches around the edge of the trilobite
(not around the edge of the rectangle, around the edge of the
trilobite pattern on the rectangle – follow the dotted line in the
diagram to the left). Continue in the round.
Round 1: p – (60)
Increase four stitches in each of the next three rounds. Increases
are worked using pfb and all other stitches are purled. Space the
increases randomly – you are knitting a rock so it should be a little
uneven.
Rounds 5 to 9: p – (72)
Decrease four stitches in each of the following rounds until only 20
sts remain. Decreases are worked using p2tog and all other stitches
are purled. Again space the decrease randomly.
Making Up:
Lightly stuff the knitted rock.
Divide the remaining stitches evenly between
two needles and cut the yarn leaving a tail for
sewing up. Thread the loose end of yarn onto a
tapestry needle and hold the two knitting
needles together so that the tail of yarn is at
the top right. We are now going to graft the
two sides of the opening together using reverse
Kitchener Stitch.
Insert the tapestry needle k-wise into the first
stitch on the front needle then p-wise into the
first stitch on the back needle.
The next four steps form the Kitchener stitch. Repeat until all stitches have been grafted together.
Insert the tapestry needle:
1. p-wise into the first stitch on the front needle, slip this stitch off the needle.
2. k-wise into next stitch on front needle, leave this stitch on the needle.
3. k-wise into the first stitch on the back needle, slip this stitch off the needle.
4. p-wise into the next stitch on the back needle, leave this stitch on the needle.
Sew in the remaining loose end.
w w w.o d d k n i t .c o m/ p a tt e r ns / fo s s i l s/ t r i l o b i t e .h t m l
Notes:
Abbreviations
[ ] x number Repeat the section in square brackets the required number of times.
(number) Gives the total number of stitches you should have on needle by the end of the row.
k number Knit this number of stitches.
p– Purl every stitch to the end of the row.
p number Purl this number of stitches.
pfb Purl into the front and then the back of a single stitch (+1 stitch).
p2tog Purl the next two stitches together (-1 stitch).
Needle/Yarn Size
As with most ODDknit patterns the yarn and needle sizes in the "you will need" section are just a guide. Feel free to
improvise with whatever needles and yarn you have lying around - that's half the fun!
w w w.o d d k n i t .c o m/ p a tt e r ns / fo s s i l s/ t r i l o b i t e .h t m l
