LAPOX® PAA-360
Technical Data Sheet | Polymers Business
Description Lapox PAA-360 is high viscosity formulated polyamide hardener available in form of 50%
solution in water. It provided relatively long pot life with epoxy resin at ambient temperature.
It is suitable for protective coatings for porous substrates. It provided coatings that
impervious to water which helps for water proofing of concrete structure. If often formulated
with mineral fillers and further diluted with water for moisture barrier coatings.
Advantages Can be diluted with water
Good inter-coat adhesion
Excellent adhesion to concrete
Applications Moisture barrier applications
Processing Coatings and sealant
Typical specifications Properties Unit Test method Values
Appearance - Visual Yellow brown liquid
Color GS ASTM D1544 Max 10
Amine value mgKOH/gm ASTM D2073 130-160
Viscosity at 25°C mPa s ASTM D2196 35000 - 55000
Specific gravity at 25°C -- -- 1.05
Solid content, 105°C /2h % -- 48 - 52
Pot life at 25°C1 minutes ASTM D2471 70 - 90
Recommended ratio w/w -- 150
1
Pot life of 100 gm mix mass at 25°C. Mixing ratio of B-11: PAA-360 is 100:150 w/w
Packaging Lapox PAA-360 is available in 200 kg MS | HDPE drums. Other packing may be considered
on request.
Storage and handling Lapox PAA-360 should be stored in a cool and dry place, preferably in a sealed container
and should not be exposed to direct sunlight. This product has a shelf life of one year, if
stored in its original container between 18°C and 25°C away from humidity and excessive
heat.
Safety Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case
of direct contact and irritation, the resin should be washed off immediately with soap and
warm water. Avoid breathing vapours, mist or gas. Please refer to the Safety Data Sheet
(SDS) of Lapox PAA-360 for detailed safety instructions.
Aug 2019 Page 1 of 2
LAPOX® PAA-360
Technical Data Sheet | Polymers Business
Spills and disposal In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable,
closed containers for disposal. Soak up with an absorbent such as clay, sand or other
suitable material. Flush area with water to remove trace residue. Do not allow the product
to reach the sewage system. Waste must be disposed of in accordance with federal, state
or local regulations, as applicable.
Contact E-mail: polymers@atul.co.in
Website: www.atul.co.in
Note Lapox® is a registered trademark of Atul Ltd.
Manufacturing site Atul 396 020, Gujarat, India
Telephone: (+91 2632) 230000 | 233261
E-mail: contact@atul.co.in
Disclaimer: The information contained herein is for information purposes only. While enough care is taken in disclosing the information, users of this
information are advised to cross-check the same depending upon use | application. Atul Ltd does not give any assurance or warranty or guarantee in
regard to the accuracy or completeness of the information and no claim or liability will be accepted or entertained in regard thereto. Atul Ltd makes no
warranty of any kind, expressed or implied, including, but not limited to, any implied warranty of merchantability or fitness for a particular purpose or
performance or usage of trade.
Aug 2019 Page 2 of 2
