LAPOX® ARD-60
Technical Data Sheet | Polymers Business
Description Lapox ARD-60 is a low viscosity, aliphatic diepoxide reactive diluent based on 1,4 butane
diol offers high level of purity compared to Lapox ARD-51. Lapox ARD-60 is compatible
with all types of epoxy resin in any proportion. Resins diluted with it can be suitably cured
by epoxy curing agents for variety of applications. Higher proportion imparts flexibility in
cured system and hence affects glass transition temperature significantly.
Chemical structure
O
O O
CH2 O
4
Advantages High resistance to solvents and ammonia
Improves wetting and processability
Practically no reduction of hardness
Provides good flexibility
Reduces viscosity while maintaining most cured properties
Applications Civil engineering and flooring
Electronic encapsulation
FRP composites
Structural adhesives
Vacuum pressure impregnation
Typical specifications Properties Unit Test method Values
Appearance - Visual Clear liquid
Colour GS ASTM D1544 Max 1
Epoxy value Eq/kg ASTM D1652 8-9
Epoxy equivalent weight (EEW) g/eq ASTM D1652 111 - 125
Viscosity at 25°C m Pas ASTM D2196 15 - 22
Hydrolysable chlorine % ASTM D1726 Max 0.15
Packaging Lapox ARD-60 is available in 200 kg MS drums and 1,000 kg IBC. Other packing may be
considered on request.
Storage and handling Lapox ARD-60 should be stored in a cool and dry place, preferably in a sealed container
and should not be exposed to direct sunlight. This product has a shelf life of 2 years if
stored in its original container between 2°C and 40°C away from humidity and excessive
heat.
August 2017 Page 1 of 2
LAPOX® ARD-60
Technical Data Sheet | Polymers Business
Safety Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case
of direct contact and irritation, the resin should be washed off immediately with soap and
warm water. Avoid breathing vapours, mist or gas. Please refer to the Safety Data Sheet
(SDS) of Lapox ARD-60 for detailed safety instructions.
Spills and disposal In case of spills, sweep up and shovel the spilled material. Keep spilled material in
suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or
other suitable material. Flush area with water to remove trace residue. Do not allow the
product to reach the sewage system. Waste must be disposed of in accordance with
federal, state or local regulations, as applicable.
Contact E-mail: polymers@atul.co.in
Website: www.atul.co.in
Note Lapox® is a registered trademark of Atul Ltd.
Manufacturing site
Atul 396 020, Gujarat, India
Telephone: (+91 2632) 230000 | 233261
E-mail: contact@atul.co.in
Disclaimer: The information contained herein is for information purposes only. While enough care is taken in disclosing the information, users of this
information are advised to cross-check the same depending upon use | application. Atul Ltd does not give any assurance or warranty or guarantee in
regard to the accuracy or completeness of the information and no claim or liability will be accepted or entertained in regard thereto. Atul Ltd makes no
warranty of any kind, expressed or implied, including, but not limited to, any implied warranty of merchantability or fitness for a particular purpose or
performance or usage of trade.
August 2017 Page 2 of 2
