LAPOX® B-11
Technical Data Sheet | Polymers Business
General purpose Bisphenol-A based liquid epoxy resin
Description Lapox® B-11 is an unmodified, medium viscosity, liquid epoxy resin based on Bisphenol-A.
When it is used with an appropriate epoxy curing agent, it provides an excellent
combination of mechanical, thermal, chemical and physical properties.
Chemical structure
O O O
O
Applications Adhesives
Civil construction
Coatings
Flooring
Grouting
Typical specifications Properties Unit Test method Values
Appearance - Visual Clear, viscous liquid
Colour APHA ASTM D1209 Max. 100
Epoxy value Eq/kg ASTM D1652 5.25 - 5.45
Epoxy equivalent weight (EEW) g/eq ASTM D1652 184 - 191
Viscosity at 25°C mPa.s ASTM D2196 11,000 - 15,000
Hydrolysable chlorine % ASTM D1726 Max. 0.05
Volatile content (150°C | 15 min.) % ASTM D1489 Max. 0.5
Packaging Lapox® B-11 is available in 240 kg MS | HDPE drums and 1,000 kg IBC. Other packing
may be considered on request.
Storage and handling Lapox® B-11 should be stored in a cool and dry place, preferably in a sealed container. It
should not be exposed to direct sunlight. This product has a shelf-life of 2 years, if stored in
its original container between 20°C and 40°C away from humidity and excessive heat. It
has a tendency to crystallise if stored below 20°C. Crystallisation can be reversed after
heating at 60°C. The recommended pumping temperature is between 70°C and 80°C.
Please refer to the Safety Data Sheet (SDS) for detailed instructions on storage and
handling.
Safety Wear personal protective equipment (PPE). Avoid contact with the eyes and skin.
In case of direct contact and irritation, the resin should be washed off immediately with
soap and warm water. Avoid breathing vapours, mist or gas. Please refer to the SDS for
detailed safety instructions.
Spills and disposal In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable,
closed containers for disposal. Soak up with an absorbent such as clay, sand or other
suitable material. Flush area with water to remove trace residue. Do not allow the product
to reach the sewage system. Waste must be disposed of in accordance with federal, state
or local regulations, as applicable.
March 2020 Page 1 of 2
LAPOX® B-11
Technical Data Sheet | Polymers Business
Contact E-mail: polymers@atul.co.in
Website: www.atul.co.in
Note Lapox® is a registered trademark of Atul Ltd.
Manufacturing site
Atul 396 020, Gujarat, India
Telephone: (+91 2632) 230000 | 233261
E-mail: contact@atul.co.in
Disclaimer: The information contained herein is for information purposes only. While enough care is taken in disclosing the information, users of this
information are advised to cross-check the same depending upon use | application. Atul Ltd does not give any assurance or warranty or guarantee in
regard to the accuracy or completeness of the information and no claim or liability will be accepted or entertained in regard thereto. Atul Ltd makes no
warranty of any kind, expressed or implied, including, but not limited to, any implied warranty of merchantability or fitness for a particular purpose or
performance or usage of trade.
March 2020 Page 2 of 2
