We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
B ENGINE
SECTION AC C
ACCELERATOR CONTROL SYSTEM
CONTENTS
ACCELERATOR CONTROL SYSTEM .sorcrornne
Removal and Installation 2
REMOVAL 2
INSTALLATION 2
INSPECTION AFTER INSTALLATION 2
Revision; 2004 Apri ACC-1 2003 FX ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM PFP-16005
Removal and Installation sown
SEC.180
43-5.91m
(0.44 - 0.80 kgem, 39 - 52 Ineb)
Front
4. Acvelerator pedal assembly
REMOVAL
1, Disconnect accelerator pedal position sensor hamess connector.
2, Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
+ Do not disassemble the accelerator pedal assembly. Do not remove the accelerator pedal posi-
tlon sensor from the accelerator pedal assembly.
+ Avoid impact from dropping etc. during handling.
+ Be careful to keep the accelerator pedal assembly away from water.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER INSTALLATION
+ Check that the accelerator pedal moves smoothly within the whole operation range.
+ Check that the accelerator pedal securely retums to the original position.
+ For the electrical inspection of the accelerator pedal position sensor, refer to EC-1247, "DTC P2138 APP
SENSOR"
CAUTION:
When the harness connector of the accelerator pedal position sensor is disconnected, perform
"Accelerator Pedal Released Position Learning’. Refer to EC-703, “Accelerator Pedal Released
Position Learning”
Revision; 2004 April ACC-2 2003 FX
