Scribd
Upload
61 views2 pages

Assignment 1

This practical assignment focuses on terminating and testing Ethernet cables using RJ45 connectors. It includes detailed instructions on preparing the cable, arranging wires according to T568B standards, crimping the connectors, and testing the cable for connectivity. The assignment is scored based on the completion of each step with specific marks allocated to each task.

Uploaded by

K.M.S Wijesinghe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
61 views2 pages

Assignment 1

This practical assignment focuses on terminating and testing Ethernet cables using RJ45 connectors. It includes detailed instructions on preparing the cable, arranging wires according to T568B standards, crimping the connectors, and testing the cable for connectivity. The assignment is scored based on the completion of each step with specific marks allocated to each task.

Uploaded by

K.M.S Wijesinghe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Basic Networking Practical Assignment

Topic: Terminating and Testing Ethernet Cables


Objective:
To learn how to properly attach RJ45 connectors to an Ethernet cable and verify
connectivity using a cable tester.
Materials Required:
 Ethernet cable (Cat5e/Cat6)
 RJ45 connectors
 Crimping tool
 Cable tester
 Wire stripper/cutter
Instructions:
1. Prepare the Cable: (20 marks)
o Strip approximately 1.5 inches of the outer insulation from both ends of
the Ethernet cable using a wire stripper.
o Untwist and straighten the individual wires.

2. Arrange the Wires in the Correct Order: (30 marks)


o Use either T568B wiring standards .

o Arrange the wires in the correct order before inserting them into the
RJ45 connector.
3. Insert the Wires into the RJ45 Connector: (15 marks)
o Ensure each wire reaches the end of the connector and maintains the
correct order.
o Push the wires in fully and verify the alignment.

4. Crimp the Connector: (15 marks)


o Use the crimping tool to firmly press down on the RJ45 connector,
securing the wires in place.
o Repeat the process for the other end of the cable.

5. Test the Cable: (20 marks)


o Insert both ends of the cable into a cable tester.

o Turn on the tester and check the connectivity of all eight wires.
o If the tester indicates a fault, recheck the wiring and re-crimp if
necessary.

You might also like