FLOW ARROW MARKED ON TEE

NOTES
TEE SAME SCHEDULE AS PIPE 1-ALL THICKNESS VALUES AND DIMENSIONS ARE IN mm.
13MM
WELDING NECK FLANGE BOLT HOLES TO
STRADDLE C
SAME SCHEDULE AS PIPE L 2- TEE, WELDING NECK FLANGE, BLIND FLANGE, GASKETS &
BOLTS SHALL CONFORM TO THE REQUIREMENTS OF THE
GUIDE RODS PIPE MATERIAL CLASS.THE WALL THICKNESS SCHEDULE OF
TACK WELDS(TWO ASA MINIMUM) THE TEE AND OF THE WELDING NECK FLANGE BORE SHALL
C

BE AS SPECIFIED FOR THE PIPE. ROD AND TACK WELD

L

ON TOP SIDE OF GUIDE ROD

APPROX. 50 APART. C
L OF TEE
STRAINER BASKET MATERIAL SHALL CONFORM TO THE CHEMICAL COMPOSITION
TACK WELDS ON UNDERSIDE OF REQUIREMENTS OF THE TEE MATERIAL.
SUPPORT ROD APPROX. 50 APART SIZE & MAX. LENGTH OF SUPPORT & GUIDE RODS ARE
SHOWN IN THE TABLE.
BETWEEN RODS GAP DIM.
9 FOR DN50 THRU DN100 3-STRAINER BASKET SHALL BE TAGGED & FURNISHED SEPA-
SUPPORT ROD 13 FOR DN150 THRU DN250
16 FOR DN300 & LARGER RATELY FOR INSTALLATION BY ERECTOR.

4-END & SIDE ROD MATERIAL SHALL BE THE SAME AS THE

FIGURE 1-STRAINER HOUSING
SCREEN MATERIAL & DIAMETER SHALL BE THE SAME AS
(SEE NOTE "2") STRAINER BASKET TAG NUMBER
SHALL BE STAMPED ON THE OUTSIDE THE SUPPORT & GUIDE ROD DIAMETERS.
EDGE OF THE HOUSING FLANGE

BASKET SUPPORT AND GUIDE ROD DIMENSIONS TABLE FIGURE 2-STRAINER BASKET IN HOUSING
NPS 2" 21/2" 3" 4" 6" 8" 10" 12" 14" 16" 18" 20" 24"
FLANGE SIZE (SEE NOTE "3")
DN 50 65 80 100 150 200 250 300 350 400 450 500 600
ROD DIA. 6 6 6 6 10 10 10 13 13 13 13 13 13

MAX. TOTAL SUPPORT 950 950 950 1200 1650 2000 2200 2900 2300 2500 2700 3050 3450
& GUIDE ROD LENGTH D

OVERLAPPING SCREEN SPOT

WELDED AT JOINT C C
A A

D
B B
E E PLAN
END FRAME ROD SEE DETAIL "G"

SIDE FRAME ROD BENT 180 SEE DETAIL "K"

O

THIS DWG. SUPERSEDES DWG. No. B-0-5049

PLAN
STRAINER
BODY AXIS

45 45
O O

END FRAME ROD SECTION D-D SECTION C-C

WELDED TO SIDE
SCREEN SIDE FRAME ROD SCREEN FRAME ROD

45°

SECTION A-A SECTION B-B 3

2
WELD GROUND OFF
1
REV. DESCRIPTION DATE

IRANIAN PETROLEUM STANDARDS

VIEW "F "
WELDS GROUND OFF TO ALLOW
FOR OVERLAPPING OF SCREEN AND
ENDS OF SCREEN JOINT SLIDING OF FRAME IN STRAINER BODY
BY SPOT WELDING WIRES
TOGETHER NO REVISION PERMITTED UNLESS APPROVED BY STANDARD ORGANIZATION
CLOSED END

DETAIL "K" DETAIL "G"

VIEW "F" SECTION E-E
"T" TYPE SUCTION STRAINER
FIGURE 3-STRAINER BASKET
SUPPORT FRAME OF DATE DRAWING No. SHEET REV.
(SEE NOTE "4")
SCREEN FOR 12"(DN300) & LARGER
IPS-D-PI-114
1
1