****************************************************************
**********RNC commands*******
>strt- show all node-B status in the RNC
>lt plug- Show all boards
>altk ---show service degraded and zero traffic cells in the RNC
>st [interface--show all MO defined
>get (proxy)--to show specific MO
>get.vlanid --show vlan
>st plug --show no. of cards
>st ip--show all boards with IP addresses
>cabx--to show the status of all boards
>set <proxy> ipAddress <new ip>--to change board ip address
>get Iub_"proxy"
>get ntp---to check clock status
>ldeb < 18649> to unlock the link
>uer-to check traffic
>get . caxfan--to see the CAX units
>alt --shows alarms
>st m3ua--to see the status of m3ua link-
>st m3ua 0--to see the disabled M3ua link
>st m3ua 1--to see the enabled M3ua link
>st ranap----to see the RANAP status
>st ransap----to see RANSAP status
>st .<cell id>---to see the cell status
>bl <proxy>----block the specific MO
>dbl <proxy>----deblock the specfic MO
>pmr -m 3 -r 3 ...... shows performance report
>get synchronization...to see clock status
>st utrancell=<U2537A>---check cell status
>get config---to see CV
>ntp config info---to see NTP config information
>cabx----see all board status
>lst .u2097---see status of site channel level
>st ranap----to check connection with core ntk
>st utrancell=U2537A---check cell status
>lga---show history alarm
>get feature---see different features
>get . license--shows different licenses
>st synch---shows the synchronization of all iub link
>sts ----shows synchronization link of active and standby ones.
>cv ls---lists the current software version
>acc <Proxy no.> manualRestart---restart one slot of RNC
>uer -r iub_2092---see Node B traffic
>get utrancell lac---printout the defined LAC in the RNC
>get utrancell rac---printout the defined RAC in the RNC
>lst IpAccessHostPool---shows the IP access of all interfaces
>lst IpAccessHostet----shows the EPB configuration to d/nt
interfaces with their corresponding proxies.
>facc <proxy> ping <Ip Adress>----pinging d/nt interfaces from
specific EPB(proxy)
>lget utran primarysc : To find power and scarmbling codes.
>st all dis ......shows all disabled MOs.
> lgaevs 5h……….history alarm for the last 5 hours
>pr location area ……print out the LAC under the RNC
> invl……to show RNC capacity
> get U2120 localcellid ---to check the configured local cell id of
the node from RNC side.
> get UtranCell=U2445 uarfcnDl desplays the uplink carrier configured
>get UtranCell=U2445 uarfcnUl desplays the downlink carrier
configured
>get Iub_2655 – IUB to get EPB location &information of the node
from RNC
>st IubLink=Iub_2656 – to check IUB status
>get utrancell ps ---checks the PS service of all cells in the RNC.
>get U2240 ps --- check the ps service of nodeB.
>stegr ----shows all CMXB3 connections with CAX unit
****** For Node-B operation*******
>lga ----show history alarm of a site
>get radio no ----shows traffic status on each carrier
>acc 0 manualrestart---to restsrt a site manually
>st sync--show cloack status
>st plugin --show status of boards
>alt---shows current alarms
>st cell---to see cells status
>pmr -m5 -p3----get performance report for the last 5hours +3
>get 0----show RBS type
>st rru----the lock status of the site
>lbl ru ---block the rru
>ldeb ru ---deblock ru
>acl <Proxy>---to show the possible MO operation
>get . cell ---to check cell id
>get . fqband ----to check the frequency used
>st cell ---cell status
>get . mixed ----to check mixed status
>cabx ---to check operational status, rru tupe,SWR level
>ntprecover accept ---to clear NTP alarms
>Get . gps ---to see the GPS status]
e.g acl rru –shows the possible rru operations
>get . channel ---to get the number of channel element(CE) for both
UL & DL
> lget U2323B5 primarys –to see scrambling code in cell level.
>get . mix -----check the mixed mode status
> get . ntpServerIpAddress---to see ntp IP address
>get tmadeviceset – to check the site is TTMF
For SW upgrade
>pr pack --to list all the installed package
>set . rollbackon false – to disable rollback
>cvcu - to see the current version
>sdir – check sector power level status
>del <proxy> to delete the version
