MODEL SolarCharger SOLAR CHARGER CONTROLLER 12V/24V WITH MPPT

VOLTAGE CONFIGURATIONS 12 and 24Vdc Auto-Detection

Adopting advanced MPPT technology, Solar Charger
photovoltaic charge controller is the key component in off-grid
RATED CHARGING CURRENT 40 Amp or stand alone solar power generation system. Solar Charger
RATED LOAD CURRENT 15 Amp can track the maximum power point and transfer the energy
to various types of batteries. The build-in MPPT
MAXIMUM PV OPEN VOLTAGE 55Vcd
microprocessor enables Solar Charger to increase the
TYPICAL IDLE POWER < 10mA charging current up to 30% compared to traditional charge
BULK CHARGE 14.6Vcd / 29.2Vcd controllers. Easy installation and capable of paralleled
connection, Solar Charger is the perfect solution for home to
FLOATING VOLTAGE 13.4Vcd / 26.8Vcd large solar system applications
EQUALIZATION VOLTAGE 14.0Vcd / 28.0Vcd Technical Features:
OVER CHARGING PROTECTION 14.8Vcd / 29.6Vcd - High converting efficiency higher than 97% for minimizing
energy loss;
LEAD ACID BATTERY SETTINGS Adjustable - Build-in MPPT tracker for optimizing the power
NiCad BATTERY SETTING Adjustable transformation;
1. Low Voltage Reconnect (LVR): Adjustable
- Reversed current protection for preventing equipment
LOAD CONTROL MODE damage;
2. Low Voltage Disconnect (LVD): Automatic disconnection
- Automatic battery temperature compensation for long-term
OPERATING TEMPERATURE 0-40°C (De-Rating at 40∼60°C) reliability;
OPERATING ALTITUDE 5000 Meters - Capable of selecting different charging mode for various
type of batteries;
CHASSIS LEVEL IP21
- Capable of connecting additional DC load for wider
RECOMMENDED WIRE SIZE #8 AWG applications;
COOLING Natural Cooling - Three stage charge control system (bulk, absorption and
float mode) with temperature compensation;
BATTERY TEMPERATURE SENSOR Optional - LED indicators display charge status in real time;
DIMENSIONS (DxWxH) 192 x 140 x 66 mm - Pulse Width Modulation (PWM) topology combined with a
CODE 50080 multi-stage charge control algorithm leads to superior
charging and enhanced battery performance.

SOLAR CHARGE CONTROLLER 12V/24V

This new range of multi-voltage (12V/24V) solar charge controllers from 10A to 30A with a 3 or 4
stage charge control system can load up to 2 battery banks simultanuously (cod.50075).
They find ideal application in stand-alone photovoltaic plants, on boats, campervans,
street-lighting, according to the model.
MODEL LP12/24-10A SH12/24-10A SH12/24-20A SH12/24-30A SH12/24-10A-2
Output Volts 12/24V 12/24V 12/24V 12/24V 12/24V
Maximum current 10A 10A 20A 30A 10A
Max charge voltage 14.4/28,8V 14.4/28.8V 14.4/28.8V 14.4/28.8V 14.4/28.8V
Cod. 50062-50061 Cod. 50065
Load disconection 11.1/22.2V 11.1/22.2V 11.1/22.2V 11.1/22.2V 11.1/22.2V
Load reconnection 13.1/26.2V 13.1/26.2V 13.1/26.2V 13.1/26.2V 13.1/26.2V
Charge mode 4 stage 4 stage 4 stage 3 stage 3 stage
N° of output 1 1 1 1 2
Operating temperature -35/+55°C -35/+55°C -35/+55°C -20/+50°C -35/+55°C
Protection degree IP22 IP22 IP22 //

Type Street-light Stand Alone Stand Alone Stand Alone Stand Alone -
Boat/Camper Boat/Camper Boat/Camper Boat/Camper
LCD Display No No No Si No
Cod. 50075 Cod. 50068 CODE FVG ENERGY 50062 50061 50065 50068 50075
 CARICABATTERIE SWITCHING

20911
20909 20913
20912

SWITCHING BATTERY CHARGERS “SBC” - WALL MOUNTED:

Simultaneously handle up to 3 separate banks of batteries supplying each one with the required current. Fully automatic. 3-stage charging system
(normal, boost and floating) for a 100% charge and long battery life. They can be used as an independent power supply unit without the need of backup
batteries. Switching mode technology allows minimum weight and dimensions. Possibility of connecting more battery chargers in parallel. They also
operate with very low AC mains voltage (180V). Dual voltage power supply (115/230V) that make them suitable for worldwide use. Protection against
reverse polarity, short circuit, and overheating. Input and output fuses. Forced ventilation through 2 electronically controlled fans. 3/5 LED controls.

Code Input Volt Input Amp Output Volts Charge voltage Charge voltage Out DC (Amp) Dimensions mm Net Weight Kg Operating
(230V) floating Booster Temperature
20911 110 or 220V 4A 12V 13.4-13.8V 14.1-14.5V 60A 340x300x80 4 Kg -10/+50°C
20912 110 or 220V 7A 24V 26.8-27.6V 28.2-29V 50A 340x300x80 4 Kg -10/+50°C
20909 110 or 220V 7A 24V 26.8-27.6V 28.2-29V 30A 310x230x80 4 Kg -10/+50°C
20913 110 or 220V 14A 24V 26.8-27.6V 28.2-29V 100A 340x300x180 7 Kg -10/+50°C

REMOTE CONTROL:
Remote control panel with 6 mt cable. With
ampere out indicator.
Dimensions mm: 130 x 65 x 30
Suitable for code # 20909 - 20911 - 20912:
Code 20915
20915 Suitable for code # 20913:
Code 20916
20916

20890
20889
20895

PTSBC - CHARGERS
PTSBC series provides automatic multi-rate charge, with 3 charge stages. They provide short circuit protection, reverse polarity protection and over
loaded protection. Electronic cooling system with fan (only in 6A and 10A models). LED light to indicate stage. This battery chargers are suitable for cars,
trucks, agricole engines, camping and boats. The switching system allows a 100% charge and a battery long life. PTSBC's can always be connected
because are fully automatic.
Model PTSBC-212F PTSBC-1012F PTSBC-624F
Input Voltage (VAC) 90V ~ 240V 90V ~ 240V 90V ~ 240V
Frequency 50 ~ 60 Hz 50 ~ 60 Hz 50 ~ 60 Hz
Output Current 2A 10A 6A
Output Voltage 12V 12V 24V
Equalizer Charge 14.6V 14.6V 29.2V
Floating Charge 13.7V 13.7V 27.4V
Dimensions mm 115x62x33 162x90x50 162x90x50
Net Weight 0.50 Kg 0.85 Kg 0.85 Kg
Code 20889 20890 20895