GPS Vehicle Tracker
(GPS+GSM+SMS/GPRS)
User Manual
(H06)
Preface
Thank you for purchasing the tracker. This anual shows how to operate
the device smoothly and correctly. Make sure to read this manual carefully before
using this product.
1. product packaging accessories:
4P power line 1, alarm button1, MIC1, horn1, specification1, warranty card 1,
Certificate of conformity 1.
(Accessories products refer to the actual product)
2. Product
accessories
GSM four frequency system global general;
built-in switching power supply, exceed wide voltage input range: 9-24 VDC;
built-in vibration sensor, realize intelligent vehicle theft;
support the original car security; can external relays, to realize the remote control vehicle fuel
and electricity;
can be set up a hotline number for SOS call the police and security alarm;
can be set up 10 vice number for receiving device returns information;
can external SOS alarm button for emergency calls for help;
can external microphone, to realize the remote voice surveillance function;
built-in backup battery, realize the illegal cut the line alarm;
can be two-way the intercom
1Red LEDPower / state
LED state
Meaning
Flashing (0.1 seconds light, 0.1 seconds dark)
Low power alarm
Always light
Charging
Slow Flashing2 seconds light, 2seconds dark
Charge full
Dark
Low power/Shut
Slow Flashing0.1 seconds light, 2seconds dark
Working normally
2Yellow LED-GSMPower / state
LED state
Slow Flashing15 seconds light
Meaning
GSM initialization
Flashing0.1 seconds light, 2seconds dark
GSM working normally
Always light
GSM calling/GPRS start
Always dark
GSM no signal
3Blue LED-GPSPower / state
LED state
Meaning
Flashing (0.1 seconds light, 0.1 seconds dark)
GSM working normally
Always dark
GSM no signal
3.Appearance schemes
3.1product size: length is 9cm;width is 4.5cm;heigh:1cm
3.2product weight:60g
4.Preparation Installation
4.1.. Check the product
Open the package, and check product model and accessories. If there is something wrong or
missing, please contact the distributor.
4.2. Select SIM card
The selection of SIM card must follow the distributor's
suggestion.
4.3. Install SIM card
Firstly, open the cover of the tracker and the cover on the slot for SIM card; secondly, insert the
card into the slot; thirdly, fasten the slot; finally, recover the product and lock the shell tightly with
three screws.
Tips:
Don't
insert
the
SIM
card
up-side-down.
Make sure the SIM card with GPRS service.
If the SIM card has been inserted, but it requires you to input SIM PIN, please close the SIM PIN
function under the instruction of your mobile phone user s manual.
Make sure the SIM card account has enough money
4.2.Install
install the tracker is hidden installation, you'd better to install it with the help of professional
companies or workers authorized by the distributor. Please install it according to the following
instruction.
4.2.1. To avoid the thiefs destruction, the tracker should be installed in a hidden place.
4.2.2 Don't put the tracker together with the emission sources, such as the parking radar system,
alarms and other vehicle-carried communication terminals.
4.2.3You can fix the tracker with the cable tie, or glue it with wide strong sponge double-sided tapes.
4.2.4 Because the tracker has GSM and GPS antenna inside, please make sure the reception
side of GPS is upward (facing the sky), and there is no metal shelter above the tracker.
4.2.5 Suggestions are as follow: a, Hidden area under the decoration board below the front
windshield or back windshield; b, Hidden area around the front panel (with a surface made of
non-metal materials);
Attention: If there is a metal insulation or a heating layer glued in the windshield, it will reduce the efficiency of
GPS signal reception, and the GPS cant work well, you need to find other places to install again.
4.3 Terminal outlet definition
Line
definition
color
Wiring instructions
sequence
1. 2
Horn
Orange.orange
Docking horn
3. 4
3. 4
5. 6
7
8
9
10
11
MIC-,MIC+
SOS
MIC-,MIC+
GND
Off
power/oil
Original
VV+
blackred
OrangeOrange
white
black
black
Connect monitoring the microphone
Orange.
Original car security
blackthick
redthick
SOS help alarm
microphone
ground connection
Cut oil or electric
Car 12 V / 24 V battery negative
Car 12 V / 24 V battery positive
Relay that connection
The oil pump breaker relays wiring method: Coil wiring for thin white line ends respectively
(85) and fine yellow line (86), white line car power negative, fine yellow line by line relay te
rminal.
Was accused of vehicles on the fuel a combination of oil pump, the oil pump connecting po
sitive cut, oil pump is extreme combination of the relay closed end (thick green line 87 a),
and the other a pick relay public (the thick green line 30)
4.4 Terminal wiring diagram
5.Equipment connect the matters needing attention
Power supply, the original car guard against theft, broken oil and electricity control line
(4 pin)
5.1 This equipment is standard for power supply 9 V ~ 24 VDC, please choose the
original provide power supply cord, red line power positive, the black line for power
negative; When installation, please choose to separate negative power grounding
wires or by iron, don't and other ground were answered
5.2 The original car security line (green line)
5.3 Broken oil electricity control line (yellow line) to pick up off the gas and electric relay
86 feet (i.e. relay socket in the fine yellow line)
5.4 MIC line2pin
External microphones, realize voice surveillance function
5.5 SOS line2pin
External SOS switch button, used for emergency calls for help
6.1 language setting command : LE
(English model)
6.2 obtain the version number command : HGT
6.3 Restore the factory command:RST pls wait 3 minute.
6.4 APN settings command : APN: AA, XX, YY (AA is the operator, XX is user name
and YY is password)
Example:APN:cmnet,,,
6.5 IP settings command : IP: IP mode # IP address # port #
Example:IP:1#www.gps588.com#8169#
6.6 Product registration command :
ZC + password + # + phone number ( master number) + # + car station ID
Example: ZC000000 # 15888185569 # 13677198895
Note: Only after you registered successfully
6.7 Pair number set command :SPN + phone number #
Example: SPN13685456894 # 13688724474 # 1368529088 # 1358520647 #
6.8 delete the corresponding vice No.
Example: DSPN13685456894 #
6.9 delete all pair number
Example: DSPN
Reply: Delete all pair number success
6.10.query pair number
Example: FSPN
6.11 modify registration password
MP old password + new password,
Example: MP000000987654
6.12. fence set
multi-mode fence setting command : the fence code + radius +
fence mode Example: RCA999 # 1
Note:999 is fence radius;1 is fence number
fence mode is set separately
Example: RCMA1
6.13 clear fence instructions: DRC. Clear all fences
6.14 fix time and fix position
Vehicle motion:XTn(5<n<65530)
Vehicle static: NXTn(5<n<65530, Default 5 minutes)
6.15 Check , location, latitude and longitude
The status check ::DW
Replay:northern latitude22.6409533 east longitude: 114.0319983 Time:2011-08-06
10:33:11.
6.16 oil control
disconnect the power source (oil) command : DO
Open power source (oil) command : TO
6.17 Listening settings
the selected listening settings command : JT0
monitor settings: JT1
6.18 anti-theft alarm
telephone alarm command : BJMA
SMS alarm: BJMB
6.19 GPS restart: GPSCQ
6.20 Equipment restart:SBCQ
6.21 Over- speed alarm set command : ODn ((0 = <N <= 1000) 0 = close)
6.22 Many parameters Settings: SZ: IP. Port, the APN, username, password, ACC
open interval time upload, ACC closed interval time preaching.
Example :SZ:www.gps588.com,8169,cmnet,,,15,15
Example:SZ: 58.61.155.175,8169,cmnet,,,15,15
6.23 Inquire the equipment information
equipment:CX, return ID ,IP APN ,car move when the heartbeat interval time and time
interval between car stop
6.25 Security Settings
Open security: KFD, close security: GFD
Note: open security after 3 minutes, triggered alarm will only take effect
GPS vehicle positioning terminal warranty card
Special statement
1.the product have technology to change without prior notice
2.Product appearance and color is subject to change, in kind prevail.
3.Warranty card is only applicable to the IMEI number listed machines.
4.Please keep the card, show this card and the original purchase documents wh
en guarantee.
5The specific scope under warranty please see table explanation.
This card for the warranty certificate, please fill in this card and save.
Name
Phone
Address
Model
IMEI NO.
Buying date
Invoice number
Sales unit name
Sales unit address
Sales unit phone
1.Since the purchase date, non-artificial damage fault is guaranteed for one year.
2.Belong to one of the following circumstances, not warranty, but can pay for
maintenance.
1 More than the guarantee period.
2 Without our authorization, disassemble or repair damaged.
3 Water damage or destroyed printed circuit board.
4Improper installation, use, maintenance, safeguarding, caused damage.
5The process of using that caused housing, lens, built-in antennas damaged.
6 IMEI number Inside the product was damaged or not clear.
7The warranty card and the product model are inconsistent or the card is alter.
8Due to the force majeure damage.
