Product Specifications
2CPX208R
2CPX208R--V1
Single Band Twin Beam Antenna, 824960 MHz, 38 horizontal beamwidth, internal
electrical tilt with manual override.
l
Single panel design supporting two separate beams perfectly optimized at horizontal
pointing angles of +27 degrees and 27 degrees from boresight
Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt
with manual override on all arrays
Electrical Specifications
Frequency Band, MHz
Gain, dBi
Beam Centers, Horizontal, degrees
Beamwidth, Horizontal, degrees
Beamwidth, Vertical, degrees
Beam Tilt, degrees
USLS (First Lobe), dB
Front-to-Back Ratio at 180, dB
Isolation, Same Beam, dB
VSWR | Return Loss, dB
PIM, 3rd Order, 2 x 20 W, dBc
Input Power per Port, maximum, watts
Polarization
Impedance
824890
18.0
27
39
9.8
010
18
25
25
890960
18.5
27
36
9.1
010
18
25
25
1.3 | 17.7
1.3 | 17.7
-150
500
45
50 ohm
-150
500
45
50 ohm
Electrical Specifications, BASTA*
Frequency Band, MHz
Gain by all Beam Tilts, average, dBi
Gain by all Beam Tilts Tolerance, dB
Gain by Beam Tilt, average, dBi
Beamwidth, Horizontal Tolerance, degrees
Beamwidth, Vertical Tolerance, degrees
USLS, beampeak to 20 above beampeak, dB
Front-to-Back Total Power at 180 30, dB
CPR at Boresight, dB
CPR at Sector, dB
824890
17.9
0.3
890960
18.2
0.3
0 | 17.9
0 | 18.2
5 | 18.0
5 | 18.2
10 | 17.9
10 | 18.0
1.7
0.3
18
22
21
22
1.7
0.3
18
19
22
22
* CommScope supports NGMN recommendations on Base Station Antenna Standards (BASTA). To learn more about the benefits of BASTA,
download the whitepaper Time to Raise the Bar on BSAs.
General Specifications
Operating Frequency Band
824 960 MHz
Antenna Type
Multibeam
Band
Single band
Performance Note
Outdoor usage
2016CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: December 1, 2016
page 1 of 3
December 12, 2016
Product Specifications
2CPX208R
2CPX208R--V1
Mechanical Specifications
RF Connector Quantity, total
RF Connector Quantity, low band
RF Connector Interface
7-16 DIN Female
Color
Light gray
Grounding Type
RF connector inner conductor and body grounded to reflector and
mounting bracket
Radome Material
Polyester fiberglass pultrusion
Reflector Material
Aluminum
RF Connector Location
Bottom
Wind Loading, frontal
1339.0 N @ 150 km/h
301.0 lbf @ 150 km/h
Wind Loading, lateral
172.0 N @ 150 km/h
38.7 lbf @ 150 km/h
Wind Loading, rear
1350.0 N @ 150 km/h
303.5 lbf @ 150 km/h
Wind Speed, maximum
200 km/h
124 mph
Dimensions
Length
2090.0 mm
Width
504.0 mm
Depth
118.0 mm | 4.6 in
Net Weight, without mounting kit
32.5 kg
|
|
82.3 in
19.8 in
71.7 lb
Remote Electrical Tilt (RET) Information
Input Voltage
1030 Vdc
Internal RET
Low band (2)
Power Consumption, idle state, maximum
2.0 W
Power Consumption, normal conditions, maximum 13.0 W
Protocol
3GPP/AISG 2.0 (Single RET)
RET Interface
8-pin DIN Male
RET Interface, quantity
1 male
Packed Dimensions
Length
2229.0 mm
Width
593.0 mm
Depth
209.0 mm | 8.2 in
Shipping Weight
45.5 kg
|
|
87.8 in
23.3 in
100.3 lb
Regulatory Compliance/Certifications
Agency
RoHS 2011/65/EU
China RoHS SJ/T 11364-2006
ISO 9001:2008
Classification
Compliant by Exemption
Above Maximum Concentration Value (MCV)
Designed, manufactured and/or distributed under this quality management system
2016CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: December 1, 2016
page 2 of 3
December 12, 2016
Product Specifications
2CPX208R
2CPX208R--V1
Included Products
T-029-GL-E
Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (50-115mm) OD round members for panel antennas. Includes
2 clamp sets.
* Footnotes
Performance Note
Severe environmental conditions may degrade optimum performance
2016CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: December 1, 2016
page 3 of 3
December 12, 2016
