Hey @emmericp - firstly, thanks for building this great tool! I initially ran libmoon in a VirtualBox VM to get familiar with it.
Next I picked up some Intel X540-AT2 10 GbE NICs to use with it. After building libmoon I attempt to run the pktgen example, which results in no TX rate being reported.
I ran Wireshark on the machine packets were being sent to, and it appears none are being sent. Interesting, if I enable ARP in the pktgen example, I can see that the example is sending out an ARP request and is receiving a response from the remote machine.
I apologize if I have missed something obvious! Any advice is greatly appreciated. Picture attached for reference:
Hey @emmericp - firstly, thanks for building this great tool! I initially ran libmoon in a VirtualBox VM to get familiar with it.
Next I picked up some Intel X540-AT2 10 GbE NICs to use with it. After building libmoon I attempt to run the pktgen example, which results in no TX rate being reported.
I ran Wireshark on the machine packets were being sent to, and it appears none are being sent. Interesting, if I enable ARP in the pktgen example, I can see that the example is sending out an ARP request and is receiving a response from the remote machine.
I apologize if I have missed something obvious! Any advice is greatly appreciated. Picture attached for reference: