Earlier tonight I took a break from monitoring my local P25 system to check out a different network, a DMR system that has recently become active. I only monitored it for about a minute before switching back to my P25 network but now I don't get any control channels locked in at all.

I've tried adjusting the gain, re-doing the calibration, manually adjusting the PPM, and reinstalling the latest nightly build. Nothing fixes the problem. DMR control channels and analog signals do come through fine as far as I can tell.

The only other activity I did when I switched to the DMR network was importing a new list of aliases from Radio Reference, but I don't see how that would affect anything.

Back in February I had a similar issue where no P25 would decode (including P25 phase 1 standalone channels) but that was from the get-go; this latest nightly did work fine until I tried to monitor a different system. So I'm scratching my head since 0.6.1 final works normally.

Logs are attached.

20250719_011639_sdrtrunk_processing_diagnostic_report.log
20250719_011833_sdrtrunk_thread_dump.log
sdrtrunk_app.log