-
|
Hello all, Bo turned on discussions, I really thought a forum for this great firmware would be very helpful, and I would not have to pester Bo.. lol I am using 3.7.1 - I have made #define SUPPORT_LED_PINS true - So that I could get the WIFI indicator LED. But I am finding that it is always on - if I am connected to wifi or not. "#ifdef SUPPORT_LED_PINS AA is what? AutoAnswer? HS is HighSpeed.. now maybe my pin output needs to be reverse of Default? I have all wired up - I will post a picture of my wiring diagram tomorrow, need to adjust some errors I made. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
|
From what I see - there is no way to adjust the HIGH or LOW of the WIFI default in the AT commands? Also because I wanted to see if the light goes on or off.. There is no way to just DISCONNECT from the WIFI? You cannot Choose to be disconnected? |
Beta Was this translation helpful? Give feedback.
-
|
You can disconnect WiFi by Failing to connect to WiFi. If you are connected, you can enter ATW"no-ssid,no-pw", and it will immediately Disconnect, and then Fail to connect, leaving you in a disconnected state. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks Bo, I was able to do that and confirm it working. I am confident I have everything working well. |
Beta Was this translation helpful? Give feedback.
From what I see - there is no way to adjust the HIGH or LOW of the WIFI default in the AT commands?
Also because I wanted to see if the light goes on or off.. There is no way to just DISCONNECT from the WIFI? You cannot Choose to be disconnected?